Analysis of the piston engine operation on ethanol with the synthesis-gas additives

Authors

DOI:

https://doi.org/10.15587/1729-4061.2018.136380

Keywords:

alternative fuels, synthesis-gas, thermochemical recycling, indicator diagram, combustion process

Abstract

We have conducted experimental study into parameters of the piston engine 1Ch 6.8/5.4 with forced ignition operated on ethanol with different additives of the synthesis-gas in the amount to 10 %.

We used the methods of working cycle indication, as well as registering the thermal balance of the engine, which make it possible to obtain the most complete pattern that characterizes ethanol combustion with additives of the synthesis-gas, as well as to determine the relationship and influence of the composition of an additive on the basic parameters of the engine working cycle.

We have acquired and processed experimental indicator diagrams under different modes when the engine was operated with and without additives of the synthesis-gas. It was found that the engines with spark ignition operating on ethanol with additives of the synthesis-gas in the amount to 10 % demonstrate a decrease in the indicator work and specific indicator fuel consumption. A decrease in the indicator engine performance can be resolved by using small amounts of additive of the synthesis-gas for heavy loads, and maximal amounts of additives at low loads. It was determined that significant additives of the synthesis-gas to ethanol results in an increase in the maximum pressure of combustion by up to 12 % and its shift towards the upper dead point at 7° c.s.r. Increasing the additive of synthesis-gas to ethanol by larger than 10 % requires adjustments of excess air ratio and the ignition advance angle. When using the synthesis-gas additives to ethanol, the ethanol specific effective consumption reduces by 2.5...12.4 %. The obtained experimental data can be considered with a sufficiently high degree of accuracy to be correct for engines with spark ignition and a cylinder volume of 190...250 cm3.

The quantitative and qualitative results of experimental studies that we obtained have confirmed the effectiveness of using the additives of synthesis-gas to ethanol; they would also complement a mathematical model of the working cycle with empirical coefficients and dependences for each particular case

Author Biographies

Oleksandr Mytrofanov, Admiral Makarov National University of Shipbuilding Heroiv Ukrainy ave., 9, Mykolaiv, Ukraine, 54025

PhD, Associate Professor

Department of internal combustion engines

Arkadii Proskurin, Admiral Makarov National University of Shipbuilding Heroiv Ukrainy ave., 9, Mykolaiv, Ukraine, 54025

PhD

Department of internal combustion engines

Andrii Poznanskyi, Admiral Makarov National University of Shipbuilding Heroiv Ukrainy ave., 9, Mykolaiv, Ukraine, 54025

Assistant

Department of Mechanical Engineering and Manufacturing Engineering

References

  1. Levterov, A. M., Levterova, L. I., Gladkova, N. Yu. (2010). Ispol'zovanie al'ternativnyh topliv v transportnyh DVS. Avtomobil'niy transport, 27, 61–64.
  2. Kuleshko, Ya. Ya. (2013). Neobhodimost' ispol'zovaniya al'ternativnyh vidov topliva dlya avtotransporta. Molodezh' i nauka: sbornik materialov IХ Vserossiyskoy nauchno-tekhnicheskoy konferencii studentov, aspirantov i molodyh uchenyh s mezhdunarodnym uchastiem, posvyashchennoy 385-letiyu so dnya osnovaniya g. Krasnoyarska. Krasnoyarsk: Sibirskiy federal'nyy un-t. Available at: http://conf.sfu-kras.ru/sites/mn2013/section076.html
  3. Mysnik, M. I., Svistula, A. E. (2009). Analiz teplofizicheskih svoystv al'ternativnyh topliv dlya dvigateley vnutrennego sgoraniya. Polzunovskiy vestnik, 1-2, 37–43.
  4. Danilov, A. M., Kaminskiy, E. F., Havkin, V. A. (2003). Al'ternativnye topliva: dostoinstva i nedostatki. Problemy primeneniya. Rossiyskiy Himicheskiy Zhurnal, 47 (6), 4–11.
  5. Bykova, E. V., Gemonov, A. V., Lebedev, A. V. (2014). Perspektivy primeneniya toplivnogo etilovogo spirta na transporte. Vestnik FGOU VPO MGAU, 3, 26–30.
  6. Ethanol as fuel for recreational boats. Available at: http://www.dartmouth.edu/~ethanolboat/Ethanol_Outboard_Final_Report.pdf
  7. Vasilevkin, E. V., Egorov, V. N., Runovskiy, K. S. (2013). Konstruktivnye izmeneniya v DVS, neobhodimye pri perekhode na benzoetanol'nye topliva. Izvestiya MGTU «MAMI», 1 (1 (15)), 10–14.
  8. A study of the effects of running gasoline with 15 % ethanol concentration in current production outboard four-stroke engines and conventional two-stroke outboard marine engines. National Renewable Energy Laboratory. Available at: http://www.nrel.gov/docs/fy12osti/52909.pdf
  9. Azimov, U., Tomita, E., Kawahar, N. (2013). Combustion and Exhaust Emission Characteristics of Diesel Micro-Pilot Ignited Dual-Fuel Engine. Diesel Engine – Combustion, Emissions and Condition Monitoring. doi: https://doi.org/10.5772/54613
  10. Shudo, T. (2008). Influence of gas composition on the combustion and efficiency of a homogeneous charge compression ignition engine system fuelled with methanol reformed gases. International Journal of Engine Research, 9 (5), 399–408. doi: https://doi.org/10.1243/14680874jer01208
  11. Maki, D. F., Prabhakaran, P. (2011). An experimental investigation on performance and emissions of a multi cylinder diesel engine fueled with hydrogen-diesel blends. Sustainable Transport, 3557–3564. doi: https://doi.org/10.3384/ecp110573557
  12. Chatterjee, A., Dutta, S., Mandal, B. K. (2014). Combustion performance and emission characteristics of hydrogen as an internal combustion engine fuel. Journal of Aeronautical and Automotive Engineering, 1 (1), 1–6.

Downloads

Published

2018-08-15

How to Cite

Mytrofanov, O., Proskurin, A., & Poznanskyi, A. (2018). Analysis of the piston engine operation on ethanol with the synthesis-gas additives. Eastern-European Journal of Enterprise Technologies, 4(1 (94), 14–19. https://doi.org/10.15587/1729-4061.2018.136380

Issue

Section

Engineering technological systems