Modeling the elastic impact of a body with a special point at its surface

Authors

DOI:

https://doi.org/10.15587/1729-4061.2019.155854

Keywords:

elastic impact, special point at the contact surface, periodic Ateb-functions

Abstract

We have considered the elastic straight impact along a flat border of the stationary half-space of the body bounded in a zone of contact interaction by the surface of rotation, whose order is smaller than two. The feature of the problem is that for the selected case an infinite curvature of the boundary surface at a point of initial contact, from which the process of dynamic compression of bodies in time starts. In addition to basic assumptions from the quasi-static theory of elastic impact between solid bodies, we have used a known solution to the static axisymmetric contact problem from the theory of elasticity. The process of an impact at a small initial velocity is divided into two stages: the dynamic compression and the dynamic decompression. For each of them, we have built an analytic solution to the nonlinear differential equation of relative convergence of the centers of bodies' masses in time. A solution to the non-linear problem with initial conditions for the differential equation of second order at the first stage was expressed through the Ateb-sinus, and at the second stage ‒ through the Ateb-cosine. To simplify calculations, we have compiled separate tables for the specified special functions, as well as proposed their compact approximations using basic functions. It was established that an error of analytical approximations of both special functions is less than one percent. We have also derived closed expressions for computing the maximum values: compression of a body, impact strength, radius of the circular contact area, and pressure, which is limited in the center of this area. We have considered a numerical example related to the impact of a rigid elastic body against a rubber half-space. Problems of this type arise when modeling the dynamic action of pieces of a solid mineral on rubber, when they fall on the rolls of a vibratory classifier lined with rubber. Based on the results from comparing the calculated parameters of an impact, we have received good agreement between numerical results, obtained from the constructed analytical solutions, and the integration of a nonlinear equation at a computer. This confirms the reliability of the built analytical solutions to the problem on impact, which provide for the convolution of a brief process over time

Author Biographies

Vasyl Ol’shanskii, Kharkiv Petro Vasylenko National Technical University of Agriculture Alchevskikh str., 44, Kharkiv, Ukraine, 61022

Doctor of Physical and Mathematical Sciences, Professor

Department of Physics and Theoretical Mechanics

Oleksandr Spol’nik, Kharkiv Petro Vasylenko National Technical University of Agriculture Alchevskikh str., 44, Kharkiv, Ukraine, 61022

Doctor of Physical and Mathematical Sciences, Professor

Department of Physics and Theoretical Mechanics

Maksym Slipchenko, Kharkiv Petro Vasylenko National Technical University of Agriculture Alchevskikh str., 44, Kharkiv, Ukraine, 61022

PhD, Associate Professor

Department of Physics and Theoretical Mechanics

Vasyl Znaidiuk, Kharkiv Petro Vasylenko National Technical University of Agriculture Alchevskikh str., 44, Kharkiv, Ukraine, 61022

PhD

Department of Physics and Theoretical Mechanics

References

  1. Pysarenko, H. S., Kvitka, O. L., Umanskyi, E. S. (2004). Opir materialiv. Kyiv: Vyshcha shkola, 655.
  2. Ol’shanskii, V. P., Ol’shanskii, S. V. (2013). Calculation of the dynamic deflection of a beam on inelastic impact by the Cox and Saint-Venant theories. Strength of Materials, 45 (3), 361–368. doi: https://doi.org/10.1007/s11223-013-9466-x
  3. Gol'dsmit, V. (1965). Udar. Teoriya i fizicheskie svoystva soudaryaemyh tel. Moscow: Stroyizdat, 447.
  4. Kil'chevskiy, N. A. (1976). Dinamicheskoe kontaktnoe szhatie tverdyh tel. Udar. Kyiv: Naukova dumka, 319.
  5. Abrate, S. (1994). Impact on Laminated Composites: Recent Advances. Applied Mechanics Reviews, 47 (11), 517. doi: https://doi.org/10.1115/1.3111065
  6. Jones, N. (1989). Structural impact. Cambridge: Cambridge Unіv. Press, 320.
  7. Hertz, H. (1882). Ueber die Berührung fester elastischer Körper. Journal für die reine und angewandte Mathematik (Crelle's Journal), 92, 156–171. doi: https://doi.org/10.1515/crll.1882.92.156
  8. Chun, L., Lam, K. Y. (1998). Dynamic response of fully-clamped laminated composite plates subjected to low-velocity impact of a mass. International Journal of Solids and Structures, 35 (11), 963–979. doi: https://doi.org/10.1016/s0020-7683(96)00231-4
  9. Smetankina, N. V. (2016). Vibrations of laminated orthotropic shells with complex shape at impact loading. Vibratsiyi v tekhnitsi ta tekhnolohiyakh, 2 (82), 77–84.
  10. Khalili, S. M. R., Soroush, M., Davar, A., Rahmani, O. (2011). Finite element modeling of low-velocity impact on laminated composite plates and cylindrical shells. Composite Structures, 93 (5), 1363–1375. doi: https://doi.org/10.1016/j.compstruct.2010.10.003
  11. Heimbs, S., Heller, S., Middendorf, P., Hähnel, F., Weiße, J. (2009). Low velocity impact on CFRP plates with compressive preload: Test and modelling. International Journal of Impact Engineering, 36 (10-11), 1182–1193. doi: https://doi.org/10.1016/j.ijimpeng.2009.04.006
  12. Li, D. H., Liu, Y., Zhang, X. (2014). Low-velocity impact responses of the stiffened composite laminated plates based on the progressive failure model and the layerwise/solid-elements method. Composite Structures, 110, 249–275. doi: https://doi.org/10.1016/j.compstruct.2013.12.011
  13. Faggiani, A., Falzon, B. G. (2010). Predicting low-velocity impact damage on a stiffened composite panel. Composites Part A: Applied Science and Manufacturing, 41 (6), 737–749. doi: https://doi.org/10.1016/j.compositesa.2010.02.005
  14. Habil, H., Hayder, H. (2015). The low-velocity impact response of laminated composite plates with holes. Journal of Multidisciplinary Engineering Science and Technology, 2 (4), 726–733.
  15. Shtaerman, I. Ya. (1949). Kontaktnaya zadacha teorii uprugosti. Moscow-Leningrad: Gostekhizdat, 272.
  16. Abramovic, M., Stigan, I. (1979). Spravochnik po special'nym funkciyam (s formulami, grafikami i matematicheskimi tablicami). Moscow: Nauka, 832.
  17. Yanke, E., Emde, F., Lesh, F. (1977). Special'nye funkcii. Moscow: Nauka, 344.
  18. Gradshteyn, I. S., Ryzhik, I. M. (1962). Tablicy integralov, summ, ryadov i proizvedeniy. Moscow: Nauka, 1100.
  19. Fu, G. (2007). An Extension of Hertz’s Theory in Contact Mechanics. Journal of Applied Mechanics, 74 (2), 373. doi: https://doi.org/10.1115/1.2188017
  20. Sokil, B. I. (1997). Pro zastosuvannia Ateb-funktsiy dlia pobudovy rozviazkiv deiakykh rivnian, yaki opysuiut neliniyni kolyvannia odnovymirnykh seredovyshch. Dopovidi Natsionalnoi akademiyi nauk Ukrainy, 1, 55–58.
  21. Hrytsyk, V. V., Nazarkevych, M. A. (2007). Matematychni modeli alhorytmiv i realizatsiya Ateb-funktsiy. Dopovidi Natsionalnoi akademiyi nauk Ukrainy, 12, 37–42.
  22. Pukach, P. Ya. (2014). Yakisni metody doslidzhennia neliniynykh kolyvalnykh system. Lviv: Lvivska politekhnika, 288.
  23. Olshanskiy, V. P., Olshanskiy, S. V. (2018). Ateb-sine in the solution of Hertz’s problem of impact. Visnyk Natsionalnoho tekhnichnoho universytetu "KhPI". Seriya: Matematychne modeliuvannia v tekhnitsi ta tekhnolohiyakh, 3, 98–103.
  24. Olshansky, V. P., Olshansky, S. V. (2017). About the motion of the oscillator with the degree of characteristic of elasticity. Vibratsiyi v tekhnitsi ta tekhnolohiyakh, 3, 34–40.
  25. Nadutiy, V. P., Yagnyukov, V. F., Yagnyukova, I. V. (2014). Vzaimodeystvie kuskov materiala s futerovannym valkom vibracionnogo klassifikatora. Vibratsiyi v tekhnitsi ta tekhnolohiyakh, 1, 94–99.
  26. D'yakonov, V. P. (2013). Maple 8 v matematike, fizike i obrazovanii. Moscow: Solon-Press, 656.
  27. Bahvalov, N. S., Zhidkov, N. P., Kobel'nikov, G. M. (2001). Chislennye metody. Moscow: Binom, 630.

Downloads

Published

2019-02-05

How to Cite

Ol’shanskii, V., Spol’nik, O., Slipchenko, M., & Znaidiuk, V. (2019). Modeling the elastic impact of a body with a special point at its surface. Eastern-European Journal of Enterprise Technologies, 1(7 (97), 25–32. https://doi.org/10.15587/1729-4061.2019.155854

Issue

Vol. 1 No. 7 (97) (2019): Applied mechanics

Section

Applied mechanics

License

Copyright (c) 2019 Vasyl Ol’shanskii, Oleksandr Spol’nik, Maksym Slipchenko, Vasyl Znaidiuk

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.