Improving the efficiency of equipment and technology of waste briquetting

Authors

DOI:

https://doi.org/10.15587/1729-4061.2020.220349

Keywords:

carbon waste, briquetting technology, mathematical modeling, Index-E program, environmental and economic efficiency

Abstract

The present-day problem of the accumulation of carbon waste was considered in connection with the aggravating urgency. General tendencies and approximate rational compositions of unprepared polydisperse fractions of mixtures of potential raw materials during their compaction and subsequent thermolysis have been experimentally determined. It was found that with an increase in moisture or binder content, solid carbon waste becomes more plastic and viscous (from 0.6 to 0.4), the coefficient of internal friction decreases. The effect of moisture on the coefficient of external friction is less noticeable (up to a 25 % reduction). It has been determined that preheating of the charge to 80 °C contributes to a decrease in density of the resulting briquettes (on average by 5–6 %) and leads to an increase in the coefficient of elastic expansion. Briquettes, all other things being equal, are 5–10 % stronger but a 1 % increase in strength accounts for a 2 % increase in energy costs. Upon re-compaction, a noticeable change in compression properties occurs. The briquette density increases by an average of 7 %. With a lower binder content, a 14 % increase in density was obtained. In this case, the increase in strength is directly proportional to energy consumption. An increase in binder content in briquets and their re-compaction were recommended. It has been found that with the optimized operation of the boiler plants that incinerate the briquetted waste, the coefficient of expenditure per year is 32.9 % less than the value of this index when using the equipment for recovery of unprepared waste. At the same time, the coefficient of influence on the environment over a 15-year period was 28.89 % less than the value of this index when operating similar equipment. The results obtained reasonably indicate that the optimized technology of waste briquetting and subsequent incineration is characterized by a significant increase in the environmental and economic efficiency of the waste recovery process

Author Biographies

Ivan Bondarenko, Ukrainian Research Institute of Environmental Problems Bakulina str., 6, Kharkiv, Ukraine, 61166

Laboratory for Environmental Impact Assessment and Environmental Expertise

Oleksii Kutniashenko, Donetsk National Technical University Shybankova sq., 2, Pokrovsk, Ukraine, 85300

PhD, Associate Professor

Department of Environmental Protection

Andrii Toporov, Donetsk National Technical University Shybankova sq., 2, Pokrovsk, Ukraine, 85300

PhD, Head of Department

Department of Equipment for Extraction and Processing Complexes

Lyudmula Anishchenko, Ukrainian Research Institute of Environmental Problems Bakulina str., 6, Kharkiv, Ukraine, 61166

Doctor of Technical Sciences, Associate Professor

Laboratory for Environmental Impact Assessment and Environmental Expertise

Olha Ziuz, Kharkiv Regional Institute of Public Administration of the National Academy for Public Administration under the President of Ukraine Moskovskyi ave., 75, Kharkiv, Ukraine, 61000

Postgraduate Student

Department of Economic Policy and Management

Igor Dunayev, Kharkiv Regional Institute of Public Administration of the National Academy for Public Administration under the President of Ukraine Moskovskyi ave., 75, Kharkiv, Ukraine, 61000

Doctor of Public Administration Sciences, Associate Professor

Department of Economic Policy and Management

Alexandr Krakhmalyov, National Technical University "Kharkiv Polytechnic Institute" Kyrpychova, 2, Kharkiv, Ukraine, 61002

PhD, Associate Professor

Department of Welding

Olha Yavorovska, Vinnytsia National Technical University Khmelnytske shoes str., 95, Vinnytsia, Ukraine, 21021

Postgraduate Student

Department of Construction, Municipal Economy and Architecture

Olena Kostina, Donetsk National Technical University Shybankova sq., 2, Pokrovsk, Ukraine, 85300

PhD, Associate Professor

Department of Equipment for Extraction and Processing Complexes

Olha Aleksieieva, Donetsk National Technical University Shybankova sq., 2, Pokrovsk, Ukraine, 85300

PhD, Associate Professor

Department of Applied Mechanics

References

  1. Sidorenko, S. N., Shetinina, N. A., Luriy, V. G. (2005). Complex of "know-how" of processing of high-quality fuel from waste products of a municipal services and the industry. Vestnik Rossiyskogo universiteta druzhby narodov. Seriya: Ekologiya i bezopasnost' zhiznedeyatel'nosti, 1 (11), 42–46.
  2. Sagdeeva, G. S., Patrakova, G. R. (2014). Pererabotka othodov proizvodstva i potrebleniya s ispol'zovaniem ih resursnogo potentsiala. Vestnik Kazanskogo tehnologicheskogo universiteta, 17 (6), 194–198.
  3. Pashkevich, M. A., Barkan, M. Sh., Sharikov, Yu. V., Dashko, R. E., Movchan, I. B., Cheremisina, O. V. et. al. (2010). Ekologicheskie problemy megapolisov i promyshlennyh aglomeratsiy. Sankt-Peterburg, 202.
  4. Burlakovs, J., Jani, Y., Kriipsalu, M., Vincevica-Gaile, Z., Kaczala, F., Celma, G. et. al. (2018). On the way to “zero waste” management: Recovery potential of elements, including rare earth elements, from fine fraction of waste. Journal of Cleaner Production, 186, 81–90. doi: https://doi.org/10.1016/j.jclepro.2018.03.102
  5. Zaini, I. N., García López, C., Pretz, T., Yang, W., Jönsson, P. G. (2019). Characterization of pyrolysis products of high-ash excavated-waste and its char gasification reactivity and kinetics under a steam atmosphere. Waste Management, 97, 149–163. doi: https://doi.org/10.1016/j.wasman.2019.08.001
  6. Shuvalov, J. V., Nikulin, A. N. (2009). Use of the firm combustible waste in heat and power engineering. Gorniy informatsionno-analiticheskiy byulleten' (nauchno-tehnicheskiy zhurnal), 8, 374–389.
  7. Abramkin, N. I., Miroshnichenko, K. S., Dorodniy, A. V. (2018). Justification of efficient recycling and neutralization methods for municipal solid waste using promising geotechnologies. Mining Informational and Analytical Bulletin, 1, 83–91. doi: https://doi.org/10.25018/0236-1493-2018-1-0-83-91
  8. Zentsov, V. N., Fattakhov, M. M., Dimov, K. V. (2015). Historical features of the processing and recycling of waste products abroad. Istoriya i pedagogika estestvoznaniya, 4, 48–51. Available at: https://cyberleninka.ru/article/n/istoricheskie-osobennosti-organizatsii-meropriyatiy-po-pererabotke-i-utilizatsii-othodov-za-rubezhom
  9. Poryadin, A. F. (1997). Problema bytovyh othodov i puti ee resheniya. Izvestiya Akademii promyshlennoy ekologii, 1, 3–6.
  10. Vnukova, N. V., Goroh, N. P., Suhorukov, I. E., Gorbik, Yu. Yu. (2006). Problemy i perspektivy kompleksnoy utilizatsii munitsipal'nyh othodov g. Har'kova. Visnyk Kharkivskoho natsionalnoho avtomobilno-dorozhnoho universytetu.
  11. Gritsenko, A. V., Goroh, N. P., Vnukova, N. V., Korin'ko, I. V., Turenko, A. N., Shubov, L. Ya. (2005). Tehnologicheskie osnovy promyshlennoy pererabotki othodov megapolisa. Kharkiv: HNADU, 340.
  12. Mirniy, A. N., Abramov, N. F., Ben'yamovskiy, D. N., Voytko, A. M.; Mirniy, A. N. (Ed.) (1990). Sanitarnaya ochistka i uborka naselennyh mest. Moscow: Stroyizdat, 413.
  13. Popov, S. M., Popov, M. V. (2003). Ekologo-ekonomicheskaya otsenka primeneniya do-utilizatsionnoy pererabotki gorodskih tverdyh bytovyh othodov. Gorniy informatsionno-analiticheskiy byulleten' (nauchno-tehnicheskiy zhurnal).
  14. Slorach, P. C., Jeswani, H. K., Cuéllar-Franca, R., Azapagic, A. (2020). Assessing the economic and environmental sustainability of household food waste management in the UK: Current situation and future scenarios. Science of The Total Environment, 710, 135580. doi: https://doi.org/10.1016/j.scitotenv.2019.135580
  15. Azimov, R. A., Benin, A. A., Shuvalov, Yu. V., Nifontov, Yu. A., Nikulin, A. N. (2005). Poluchenie toplivnyh briketov iz tverdyh goryuchih materialov. Gorniy informatsionno-analiticheskiy byulleten', 2, 128–131. Available at: https://cyberleninka.ru/article/n/poluchenie-toplivnyh-briketov-iz-tverdyh-goryuchih-materialov
  16. Shuvalov, Yu. V., Tarasov, Yu. D., Nikulin, A. N. (2011). Obosnovanie ratsional'nyh tehnologiy polucheniya toplivno-energeticheskogo syr'ya na osnove tverdyh goryuchih uglerodsoderzhashchih othodov. Gorniy informatsionno-analiticheskiy byulleten' (nauchno-tehnicheskiy zhurnal), 8, 243–247.
  17. Kandlbauer, L., Khodier, K., Ninevski, D., Sarc, R. (2020). Sensor-based Particle Size Determination of Shredded Mixed Commercial Waste based on two-dimensional Images. Waste Management. doi: https://doi.org/10.1016/j.wasman.2020.11.003
  18. Vladimirov, S., Ermakova, L., Patrikeev, I. (2016). Binding substance at technology of briquetting of municipal solid waste. Bulletin of Science and Practice, 5, 145–148.
  19. Ermakova, L. S., Gonopol'skiy, A. M. (2010). Bezobvyazochnaya tehnologiya kompaktirovaniya tverdyh bytovyh othodov v krupnogabaritnye bloki. Himicheskoe i neftegazovoe mashinostroenie, 11, 18.
  20. Afra, E., Abyaz, A., Saraeyan, A. (2021). The production of bagasse biofuel briquettes and the evaluation of natural binders (LNFC, NFC, and lignin) effects on their technical parameters. Journal of Cleaner Production, 278, 123543. doi: https://doi.org/10.1016/j.jclepro.2020.123543
  21. Gonopol'skiy, A. M., Ermakova, L. S. (2012). Issledovanie fiziko-mehanicheskih harakteristik TBO pri ih kompaktirovanii bezobvyazochnym metodom v krupnogabaritnye bloki. Himicheskoe i neftegazovoe mashinostroenie, 2, 34–36.
  22. Gonopol'sky, A. M., Yermakova, L. S. (2012). Investigation of Technological Parameters of the Process of No-Binding Compacting of Solid-Household-Waste Blocks. Ecology and Industry of Russia, 4, 40–41.
  23. Bondarenko, I. V., Usenko, A. V. (2018). Svidotstvo pro reiestratsiu avtorskoho prava na tvir No. 75876. Kompiuterna prohrama dlia prohnozuvannia ekoloho-ekonomichnoi efektyvnosti, otsinky ta obgruntuvannia pidboru skladu tekhnichnoho zabezpechennia system povodzhennia z vidkhodamy «Indeks–E». declareted: 10.01.2018.
  24. Bondarenko, I. V., Anischenko, L. Y., Rudyk, Yu. I. (2017). Substantiation for enhancement of environmental safety of waste management systems through forecasting efficiency of specialized equipment. Visnyk Lvivskoho derzhavnoho universytetu bezpeky zhyttiediyalnosti, 16, 119–128.
  25. Bondarenko, I. V., Kutnyashenko, О. І., Rudyk, Y. І., Solyonyj, S. V. (2019). Modeling the efficiency of waste management. NEWS of National Academy of Sciences of the Republic of Kazakhstan, 2 (434), 120–130. doi: https://doi.org/10.32014/2019.2518-170x.45
  26. Bondarenko, I., Kutniashenko, О. (2018). Assessment of waste management system facilities efficiency in the conditions of small settlements. Transactions of Kremenchuk Mykhailo Ostrohradskyi National University, 6, 103–114. doi: https://doi.org/10.30929/1995-0519.2018.6.103-114
  27. Metodicheskie ukazaniya k vypolneniyu laboratornyh rabot po opredeleniyu fiziko-mehanicheskih harakteristik diskretnoy sredy (dlya studentov spetsial'nosti 0516) (1987). Donetsk: DPI, 48.

Downloads

Published

2020-12-31

How to Cite

Bondarenko, I., Kutniashenko, O., Toporov, A., Anishchenko, L., Ziuz, O., Dunayev, I., Krakhmalyov, A., Yavorovska, O., Kostina, O., & Aleksieieva, O. (2020). Improving the efficiency of equipment and technology of waste briquetting. Eastern-European Journal of Enterprise Technologies, 6(10 (108), 36–52. https://doi.org/10.15587/1729-4061.2020.220349