Development of calorimetric motor fuel flowmeter with increased metering accuracy by adjusting the inlet temperature

Authors

  • Андрій Володимирович Ільченко Zhitomir, Zhytomyr State Technological University Chernyakhovskogo 103, Zhitomir, Ukraine, 10005, Ukraine
  • Олена Миколаївна Безвесільна National Technical University of Ukraine "Kyiv Polytechnic Institute", Victory Avenue 37, Kyiv, Ukraine, 03056, Ukraine

DOI:

https://doi.org/10.15587/1729-4061.2014.28723

Keywords:

engine, temperature, metering, calorimeter, heat transfer, capacity of heat transmission, flowmeter, fuel, bio-fuel, flow

Abstract

In the paper, the emphasis is made on the diversity of motortransport operation conditions and factors which should be considered while developing modern motor fuel flowmeters. It is shown that calorimetric flowmeters correspond to the motor transport operating conditions, fuel flow metering standards and can be recommended for their usage in the process of automobiles exploitation. They also can be useful for the bio-fuel flow metering. A concept of a new calorimetric motor fuel (bio-fuel) flowmeter with adjusting the inlet temperature was developed for the car engines, having up to date supply systems (the systems of reverse fuel decanting into the tank (through recoil lines)), which allows to increase the accuracy of motor fuel flow metering. Field researches of brassboard at the automobile have shown the decrease (compared to the prototype of flowmeter) in the relative accuracy of diesel oil flow by 7–13 % depending on the engine behavior.

Author Biographies

Андрій Володимирович Ільченко, Zhitomir, Zhytomyr State Technological University Chernyakhovskogo 103, Zhitomir, Ukraine, 10005

PhD., Associate Professor

Department of automobiles and automobile establishment

Олена Миколаївна Безвесільна, National Technical University of Ukraine "Kyiv Polytechnic Institute", Victory Avenue 37, Kyiv, Ukraine, 03056

PhD., Professor,

Department of Instrumentation

References

  1. 1. Bezvesilna, E. N., Ilchenko, A. V., Tkachuk, A. G., Parkhomenko, S. O. (2013). Metodu vumiryvannya vutrat ta konstrukcii vutratomiriv [Methods of measuring fluid flow and design flowmeters]. Bulletin of Engineering Academy of Ukraine, 3-4, 216–222.

    2. Bezvesilna, E. N., Ilchenko, A. V., Trostenyuk, U. V. (2013). Kalorimetricheskiy rashodomer motornuh topliv s povushennoi tochnostyu izmereniya rashodov [Calorimetric flowmeter for motor fuels with high accuracy flow measurement]. Future direction of the motor complex. Collection of articles Penza, 14–19.

    3. In: Knothe, G., Gerpen, J., Krahl, J. (2005). The Biodiesel Handbook. Illinois AOCS Publishing, 286.

    4. Liu, S., Ding, F., Ding, C., Man, Z. (2014). A High-Pressure Bi-Directional Cycloid Rotor Flowmeter. Sensors, 14 (8), 15480–15495. doi: 10.3390/s140815480

    5. Thermal Flowmeter Technology. (2014). BCC Research. Available at: http://www.flowmeters.com/thermal-technology

    6. Boyes, W. (Ed.) (2010). Instrumentation Reference book. Ed. 4. UK: Linacre House, 530.

    7. Frenzel, F., Grothey, H., Habersetzer, C., Hiatt, M. (2011). Industrial Flow Measurement Basics and Practice. Germane: ABB Automation Products GmbH, 290.

    8. Duffy, G. J., Eng, B. (2000). Thermal mass flow measurement. Dublin City University. Available at: http://doras.dcu.ie/18552/1/Gabriel_J_Duffy.pdf.

    9. Economical thermal mass flow sensor based on constant temperature anemometry. (1999). Nurnberg, Germany. Available at: http://www.bronkhorst.com/files/published_articles/sensor99.pdf

    10. Toplivnue sistemu lszelei s nasos-forsunkami i individualnumi ТNVD [Diesel fuel system with pump-injector and solo fuel pump with high pressure] (2006). Мoscow: ZAО «Legion-Аvtodata, 48.

    11. Dizelnue akumulyatornue toplivnue sistemu Common Rail [Diesel fuel accumulathion Common Rail systems] (2005). Мoscow: ZAО «Legion-Аvtodata, 48.

    12. Polishchuk, E. S., Dorozhovets, M. M., Stadnik, B. I., Ivakhiv, O. V., Boyko T. G. (2008). Zasobu i metodu vumiryuvan neelektrichnuh velichin : pidruchnik [Means and methods of measurement of non-electrical quantities: of books]. Lviv: «Beskid Bit», 368.

    13. Spektor, S. А. (1987). Elektricheskie izmereniya fizicheskih velichin. Metodu izmerenii [Electrical measurements of physical quantities. Methods of measurement]. Energoatomizdat, 320.

Published

2014-12-18

How to Cite

Ільченко, А. В., & Безвесільна, О. М. (2014). Development of calorimetric motor fuel flowmeter with increased metering accuracy by adjusting the inlet temperature. Eastern-European Journal of Enterprise Technologies, 6(7(72), 50–54. https://doi.org/10.15587/1729-4061.2014.28723

Issue

Section

Applied mechanics