Project development of a precision installer for measuring inhomogeneous density of the solution in the process of automation of the technological software and hardware complex

Authors

DOI:

https://doi.org/10.15587/1729-4061.2022.254825

Keywords:

precision installer, optical module, inhomogeneous density of the solution, automation

Abstract

A project of a precision installer for measuring the inhomogeneous density of the solution has been developed. This module is one of the key components of an automated program-controlled complex created for the encapsulation of cell transport systems.

An analysis of existing methods for determining the values of viscosity and density shifts shows that optical measurement methods are the most appropriate for designing the precision installer due to their simplicity and reliability.

Implementation of optical measurement is also due to the need to ensure sterility of analyzed material, as well as non-destructive testing of liquid.

Using the ultrasound method requires immersion in liquid of transmitting element and receiver, which violates the principle of sterility. According to the results of measurements, it was found that the method of recording optical radiation can determine density distribution in the cuvette volume after centrifugation with a high degree of accuracy. The exact positioning of the needle for the selection of liquid has been achieved. A measuring optical module has been developed to determine the inhomogeneous density of the liquid.

Accurate positioning of the carousel at given points by mounting permanent neodymium magnets in the base of cuvette compartments has been achieved.

The simplification of measuring configuration by the exclusion of dispersive elements, filters and the monochromator significantly reduces the cost of measuring equipment and makes it easy to implement for solving such problems.

The introduction of modern digital technologies into the project makes it possible to process signal packets from positioning sensors and through individual channels, which is especially important for automating measurement and positioning processes, taking into account sterility

Supporting Agency

  • This research is funded by the Science Committee of the Ministry of Education and Science of the Republic of Kazakhstan. Grant № AP09258926.

Author Biographies

German Seredin, Private Institution «National Laboratory Astana» Nazarbayev University

Engineer, Leading Researcher

Laboratory of Biosensors and Bioinstruments

Dastan Sarbassov, LLP «R&D Engineering»

Engineer, Senior Researcher

Gulsara Berikkhanova, S. Seifullin Kazakh Agro Technical University

Head of Department

Department of Higher Mathematics

Aidar Alimbayev, Nazarbayev University

Engineer, Research Assistant

References

  1. Madadelahi, M., Madou, M. J., Nokoorani, Y. D., Shamloo, A., Martinez-Chapa, S. O. (2020). Fluidic barriers in droplet-based centrifugal microfluidics: Generation of multiple emulsions and microspheres. Sensors and Actuators B: Chemical, 311, 127833. doi: https://doi.org/10.1016/j.snb.2020.127833
  2. Clayton, A., Boilard, E., Buzas, E. I., Cheng, L., Falcón-Perez, J. M., Gardiner, C. et. al. (2019). Considerations towards a roadmap for collection, handling and storage of blood extracellular vesicles. Journal of Extracellular Vesicles, 8 (1), 1647027. doi: https://doi.org/10.1080/20013078.2019.1647027
  3. Chakhlov, V. L., Cheprasov, A. I., Shaverin, N. V. (2002). Measurements of the Density of Petroleum Products and Their Mixtures by the Ultrasonic Method. Russian Journal of Nondestructive Testing 38, 472–476. doi: https://doi.org/10.1023/a:1022187228570
  4. Plotnomery. ChemPort.Ru. Available at: http://www.chemport.ru/data/chemipedia/article_2876.html
  5. Frenkel', Ya. I. (1975). Kineticheskaya teoriya zhidkostey. Leningrad: Nauka, 592.
  6. Püttmer, A., Hoppe, N., Henning, B., Hauptmann, P. (1999). Ultrasonic density sensor—analysis of errors due to thin layers of deposits on the sensor surface. Sensors and Actuators A: Physical, 76 (1-3), 122–126. doi: https://doi.org/10.1016/s0924-4247(98)00365-3
  7. Puttmer, A., Hauptmann, P. (1998). Ultrasonic density sensor for liquids. 1998 IEEE Ultrasonics Symposium. Proceedings (Cat. No. 98CH36102). doi: https://doi.org/10.1109/ultsym.1998.762197
  8. Kolesnikov, A. E. (1982). Ul'trazvukovye izmereniya. Moscow: Izd-vo standartov, 248. Available at: https://search.rsl.ru/ru/record/01001126714
  9. Ermolov, I. N., Lange, Yu. V. (2004). Ul'trazvukovoy kontrol'. Nerazrushayuschiy kontrol'. Vol. 3. Moscow: Mashinostroenie, 864.
  10. Gitis, M. B., Chuprin, V. A. (2012). Primenenie ul'trazvukovykh poverkhnostnykh i normal'nykh voln dlya izmereniy parametrov tekhnicheskikh zhidkostey. 1. Izmerenie sdvigovoy vyazkosti. Zhurnal Tekhnicheskoy Fiziki, 82 (5), 93–99. Available at: https://journals.ioffe.ru/articles/viewPDF/10603
  11. Chuprin, V. A. (2014). Optimization of ultrasonic device parameters for measurements of lubricants viscosity for in-line condition diagnostics of machine equipment. Part 1. Kontrol’. Diagnostika, 188 (2), 15–23. doi: https://doi.org/10.14489/td.2014.02.pp.015-023
  12. Zhu, Z., Wu, J. (1995). The propagation of Lamb waves in a plate bordered with a viscous liquid. The Journal of the Acoustical Society of America, 98 (2), 1057–1064. doi: https://doi.org/10.1121/1.413671
  13. Qu, J., Berthelot, Y., Li, Z. (1996). Dispersion of Guided Circumferential Waves in a Circular Annulus. Review of Progress in Quantitative Nondestructive Evaluation, 169–176. doi: https://doi.org/10.1007/978-1-4613-0383-1_21
  14. Bekker, Yu. (2009). Spektroskopiya. Moscow: Tekhnosfera, 528.
  15. Furtado, A., Gavina, J., Napoleão, A., Pereira, J., Cidade, M. T., Sousa, J. (2019). Density measurements of viscoelastic samples with oscillation-type density meters. Journal of Physics: Conference Series, 1379 (1), 012020. doi: https://doi.org/10.1088/1742-6596/1379/1/012020
  16. Teutsch, T., Mesch, M., Giessen, H., Tarín, C. (2017). Refractive Index Estimation from Spectral Measurements of a Plasmonic Glucose Sensor and Wavelength Selection * *The project was funded by Baden-Württemberg Stiftung gGmbH. The authors would also like to thank MWK BW, ERC COMPLEX-PLAS and AvH Stiftung. IFAC-PapersOnLine, 50 (1), 4406–4411. doi: https://doi.org/10.1016/j.ifacol.2017.08.913
  17. Kadlec, K. (2018). Measurement of Process Variables in Sugar Industry: Density Measurement of Liquid Mixtures (Part 1). Listy Cukrovarnické a Reparské, 134, 122–127. Available at: https://www.proquest.com/docview/2017962288?accountid=134066&forcedol=true#
  18. Shmidt, V. (2007). Opticheskaya spektroskopiya dlya khimikov i biologov. Moscow: Tekhnosfera, 378.
  19. Fedorova, V. N., Faustov, E. V. (2008). Meditsinskaya i biologicheskaya fizika. Kurs lektsiy s zadachami. Moscow, 592. Available at: https://ru.calameo.com/read/0018041806b723b611a63
  20. Bykovskiy, S. N., Vasilenko, I. A., Kharchenko, M. I. (Eds.) (2014). Rukovodstvo po instrumental'nym metodam issledovaniy pri razrabotke i ekspertize kachestva lekarstvennykh preparatov. Moscow: Izd-vo «Pero», 656.
  21. Brekhovskikh, L. M., Godin, O. A. (1989). Akustika sloistykh sred. Moscow: Nauka, 416.

Downloads

Published

2022-04-30

How to Cite

Berikkhanova, K., Seredin, G., Sarbassov, D., Berikkhanova, G., & Alimbayev, A. (2022). Project development of a precision installer for measuring inhomogeneous density of the solution in the process of automation of the technological software and hardware complex. Eastern-European Journal of Enterprise Technologies, 2(5 (116), 17–24. https://doi.org/10.15587/1729-4061.2022.254825

Issue

Section

Applied physics