Construction of intelligent decision support system in control of gas compression process

Authors

  • Леонид Михайлович Замиховский Ivano-Frankivsk National Technical University of Oil and Gas Carpathian 15, Ivano-Frankivsk, Ukraine, 76019, Ukraine
  • Роман Михайлович Матвиенко Ivano-Frankivsk National Technical University of Oil and Gas Karpatska 15, Ivano-Frankivsk, Ukraine, 76019, Ukraine

DOI:

https://doi.org/10.15587/2313-8416.2015.41213

Keywords:

intelligent system, decision support system, dispatcher, operator, gas compression process

Abstract

The necessity to construct the intelligent decision support systems (IDSS) in the control of the gas compression process with inclusion in structure of the training module is substantiated. А block diagram of human-computer interaction in the system "Dispatcher - IDSS - ASC GCU - CS" is shown, and the functions of the separate blocks of the intellectual decision support system in the control of the gas compression process are defined

Author Biographies

Леонид Михайлович Замиховский, Ivano-Frankivsk National Technical University of Oil and Gas Carpathian 15, Ivano-Frankivsk, Ukraine, 76019

Doctor of Technical Sciences, Professor Head of the department

Department of computer technology in control and automation

Роман Михайлович Матвиенко, Ivano-Frankivsk National Technical University of Oil and Gas Karpatska 15, Ivano-Frankivsk, Ukraine, 76019

Assistant

Department of Computer Technologies in Control Systems and Automation

References

Automatic control system of gas-pumping aggregates: General requirements. (2006). Moscow: “Gazprom”, “Orgenergogaz”.

Slobodchikov, K. Yu. (2009). Algorithms of mode control of compressor workshop in distributed structure of software controller. Eastern-European Journal of Enterprise Technologies, 3/3(39), 80–87.

Zamykhovskyi, L. M., Skrypiuk, R. B. (2014). Using WinCC SCADA-system for creation simulator of dispatcher of compressor station. Young scientist, 9, 154–158.

Slobodchikov, K. Yu. (2002). Problems of ergonomic research of development process of interface of systems “Man-computer-ACS TP”. Bulletin of the Kharkov Automobile and Road Technical University and North-Eastern Scientific Center of Transport Academy of Ukraine, 17, 100–102.

Timofeiev, V. A., Tulupov, V. V. (2004). Rating system of operator activity in distance learning on simulator. Proceedings of 8th International Conference “Education and Virtuality – 2004”, 157–162.

Zamykhovskyi, L. M., Matviienko, R. M. (2009). Computer complex for training operators of gas-pumping aggregates. Proceedings of IV International Scientific and Technical Conference “Computer technology of decision support in dispatcher control of gas transport and production systems” - DISCOM-2009, 422–430.

Bukhvalov, R. I. (2007). Methods and algorithms for information support of control of gas transport system. Vladimir, 133.

Horbiichuk, M. I., Shchupak, I. V., Kimak, V. L. (2010). Method of integrated assessment of the technical state of gas pumping aggregates. Oil and gas energy, 2, 38–43.

Skripka, O. A. (2007). Control of technical condition of centrifugal pumps of gas-pumping aggregates on principles of neural networks. Ivano-Frankivsk, 222.

Idrisov, I. I. (2009). Algorithms of adaptation and fault tolerance of turbine engines control systems based on neural network technology. Ufa, 19.

Dushkov, B. A., Lomov, B. F., Smirnov, B. A. (1991). Reader on engineering psychology. Moscow: Higher School, 287.

Strelkov, Yu. K. (2001). Engineering and professional psychology. Moscow: Academy.

Matviienko, R. M. (2010). Comparative characteristics of object-oriented environments WinCC and LabVIEW to create computer training complexes. Scientific news of IME “Halytska Akademіya” (engineering sciences), 17 (1), 120–126.

Published

2015-04-27

Issue

Section

Technical Sciences