The dimensional accuracy of the sintered billets

Authors

  • Чингиз Ариф оглы Алиев Azerbaijan Technical University 25 Huseyn Javid ave., Baku, Azerbaijan, AZ1073, Ukraine

DOI:

https://doi.org/10.15587/2313-8416.2016.58770

Keywords:

dimensional accuracy, sintered billet, density, analytical expression, oxide, variation

Abstract

The article presents the results of assessing the impact of the behaviour stability of the components included in the compositions and process parameters of their production, on the dimensional accuracy of workpieces. It was found that by increasing the amount of oxide in the composition is greater compaction of the sintered billet in the process of heat treatment. This also increases the density of all components of the composition

Author Biography

Чингиз Ариф оглы Алиев, Azerbaijan Technical University 25 Huseyn Javid ave., Baku, Azerbaijan, AZ1073

Doctoral Student

References

Korolev, Ju. M., Ljul'ko, V. G. (2007). Sostojanie razvitija poroshkovoj metallurgii Rossii v svete mirovyh tendencij. «Poroshkovaja metallurgija v avtotraktornom mashinostroenii». Minsk, 23–27.

Gorohov, V. M., Zvonarev, E. V., Il'jushhenko, A. F., Kireev, P. N. (2005). Ustanovka dlja teplogo pressovanija metallicheskih poroshkov-pervyj opyt primenenija dlja poluchenija izdelij slozhnoj formy. «Novye materialy i izdelija iz metallicheskih poroshkov. Tehnologija. Proizvodstvo. Primenenie». Yoshkar-Ola, 41–44.

Graboj, I. Je., Arndt, T. (2005). Materialy Catameld kompanii BASF dlja lit'ja poroshkov pod davleniem. «Novye materialy i izdelija iz metallicheskih poroshkov. Tehnologija. Proizvodstvo. Primenenie». Yoshkar-Ola, 37–40.

Mamedov, A. T. (2005). Konstrukcionnye i antifrikcionnye poroshkovye materialy. Baku: Jelm, 460.

Mamedov, A. T., Sergeeva, N. P. (1989). Osobennosti strukturoobrazovanija poroshkovyh stalej. Poroshkovaja metallurgija, 3, 101–105.

Anciferov, V. N., Akimenko, V. B. (2003). Spechennye legirovannye stali. Moscow, 188.

Published

2016-01-25

Issue

Section

Technical Sciences