A study of formation peculiarities and properties of iron coatings with refractory metals on gray cast iron SCH18

Authors

  • Анна Владимировна Каракуркчи National Technical University «Kharkіv Polytechnic Institute», Kyrpychova str., 2, Kharkiv, Ukraine, 61002, Ukraine https://orcid.org/0000-0002-1287-3859

DOI:

https://doi.org/10.15587/2312-8372.2017.93546

Keywords:

iron coating, gray cast iron, refractory metals, electrodeposition, electrolytic alloy, corrosion resistance

Abstract

The features of the formation of iron multi-component coatings with refractory metals (molybdenum and tungsten) from citrate electrolytes based on iron(III) on substrates made of gray cast iron SCH18 are studied. It is shown that the electrolysis mode and the density of cathodic polarization effect on the current efficiency, the content of alloying elements in coatings and their distribution over the surface, allowing to control electrodeposition process. It is found that with increasing current density coatings are enriched with alloying components while increasing the porosity as a result of the intensification of hydrogen release. Rational intervals of current densities are determined for galvanostatic regime and pulse polarization regime for formation of iron-molybdenum and iron-molybdenum-tungsten coatings with a high content of alloying elements, the output flow is up to 85 % and coating deposition rate of 25-30 µm/h.

It is shown that the addition of the refractory metals in the thin film results in an amorphous coating structure and formation of extended microglobular surface consisting of grains of various sizes. It is found that a high degree of surface extension and substantial contents of tungsten and molybdenum provide high wear resistance performance and corrosion resistance, and low friction coefficient compared with the substrate material. These materials can be used as reinforcement and protection in a variety of industries.

Author Biography

Анна Владимировна Каракуркчи, National Technical University «Kharkіv Polytechnic Institute», Kyrpychova str., 2, Kharkiv, Ukraine, 61002

PhD, Head of Research Laboratory

References

  1. Ved, M. V., Sakhnenko, M. D. (2010). Katalitychni ta zakhysni pokryttia splavamy i skladnymy oksydamy: elektrokhimichnyi syntez, prohnozuvannia vlastyvostei. Kharkiv: NTU «KhPI», 272.
  2. Yermolenko, I. (2014). Studying peculiarities of cathodic iron reduction from electrolytes based on Fe (III). Technology Audit And Production Reserves, 4(1(18)), 44–48. doi:10.15587/2312-8372.2014.26315
  3. Tsyntsaru, N., Bobanova, J., Ye, X., Cesiulis, H., Dikusar, A., Prosycevas, I., Celis, J.-P. (2009). Iron–tungsten alloys electrodeposited under direct current from citrate–ammonia plating baths. Surface and Coatings Technology, 203 (20-21), 3136–3141. doi:10.1016/j.surfcoat.2009.03.041
  4. Tsyntsaru, N., Dikusar, A., Cesiulis, H., Celis, J.-P., Bobanova, Z., Sidel’nikova, S., Belevskii, S., Yapontseva, Yu., Bersirova, O., Kublanovskii, V. (2009). Tribological and corrosive characteristics of electrochemical coatings based on cobalt and iron superalloys. Powder Metallurgy and Metal Ceramics, 48 (7-8), 419–428. doi:10.1007/s11106-009-9150-7
  5. Tsyntsaru, N. I., Bobanova, Z. I., Kroitoru, D. M., Cheban, V. F., Poshtaru, G. I., Dikusar, A. I. (2010). Effect of a multilayer structure and lubrication on the tribological properties of coatings of Fe-W alloys. Surface Engineering and Applied Electrochemistry, 46 (6), 538–546. doi:10.3103/s1068375510060025
  6. Donten, M., Cesiulis, H., Stojek, Z. (2000). Electrodeposition and properties of Ni-W, Fe-W and Fe-Ni-W amorphous alloys. A comparative study. Electrochimica Acta, 45 (20), 3389–3396. doi:10.1016/s0013-4686(00)00437-0
  7. Donten, M., Stojek, Z., Cesiulis, H. (2003). Formation of Nanofibers in Thin Layers of Amorphous W Alloys with Ni, Co, and Fe Obtained by Electrodeposition. Journal of The Electrochemical Society, 150 (2), C95–C98. doi:10.1149/1.1536994
  8. Cesiulis, H., Donten, M., Donten, M. L., Stojek, Z. (2001). Electrodeposition of Ni-W, Ni-Mo and Ni-Mo-W Alloys from Pyrophosphate Baths. Materials Science (Medziagotyra), 7 (4), 237–241.
  9. Nabiyouni, G., Saeidi, Sh., Kazeminezhad, I. (2012). Magnetic and nanostructural characteristics of electrodeposited supermalloy (Ni-Fe-Mo) thin films. Research and Reviews in Materials Science and Chemistry, 1 (1), 1–14.
  10. Podlaha-Murphy, E. J. (2013). Electrodeposition of Ni-Fe-Mo-W Alloys. 1st Quarterly Report January-March, 2013. AESF Research Project #R-117. NASF Surface Technology White Papers, 77 (12), 11–17.
  11. Podlaha-Murphy, E. J. (2013). Electrodeposition of Ni-Fe-Mo-W Alloys. 2nd Quarterly Report April-June, 2013. AESF Research Project #R-117. NASF Surface Technology White Papers, 77 (12), 18–27.
  12. Podlaha, E. J. (1997). Induced Codeposition. Journal of The Electrochemical Society, 144 (5), 1672–1680. doi:10.1149/1.1837658
  13. Podlaha-Murphy, E. J. (2014). Electrodeposition of Ni-Fe-Mo-W Alloys. 4th thru 6th Quarterly Reports October, 2013 – June 2014. AESF Research Project #R-117. NASF Surface Technology White Papers, 79 (2), 1–14.
  14. Sun, S., Bairachna, T., Podlaha, E. J. (2013). Induced Codeposition Behavior of Electrodeposited NiMoW Alloys. Journal of the Electrochemical Society, 160 (10), D434–D440. doi:10.1149/2.014310jes
  15. Kuznetsov, V. V., Golyanin, K. E., Pshenichkina, T. V. (2012). Electrodeposition of iron-molybdenum alloy from ammonia-citrate electrolyte. Russian Journal of Electrochemistry, 48 (11), 1107–1112. doi:10.1134/s1023193512110109
  16. Kuznetsov, V. V., Golyanin, K. E., Pshenichkina, T. V., Lyakhov, B. F., Lyashenko, S. E. (2013). Chemical composition of Fe–Mo alloys obtained by electrodeposition. Mendeleev Communications, 23 (6), 331–333. doi:10.1016/j.mencom.2013.11.009
  17. Barbano, E. P., Da Silva, F. S., Carlos, I. A., Valles, E. (2017). New electrolytic bath for electrodeposition of protective binary FeMo and ternary FeMoP films. Journal of Alloys and Compounds, 695, 319–328. doi:10.1016/j.jallcom.2016.10.208
  18. Ved’, M. V., Sakhnenko, N. D., Karakurchi, A. V., Zyubanova, S. I. (2014). Electrodeposition of iron-molybdenum coatings from citrate electrolyte. Russian Journal of Applied Chemistry, 87 (3), 276–282. doi:10.1134/s1070427214030057
  19. Karakurkchi, A. V., Ved’, M. V., Sakhnenko, N. D., Zyubanova, S. I., Yermolenko, I. Yu. (2014). Elektroosazhdenie dvojnyh i trojnyh splavov zheleza iz tcitratnyh elektrolitov. Nanotehnologii: nauka i proizvodstvo, 3 (30), 24–27.
  20. Karakurkchi, A. V., Ved’, M. V., Sakhnenko, N. D., Yermolenko, I. Y. (2015). Electrodeposition of iron–molybdenum–tungsten coatings from citrate electrolytes. Russian Journal of Applied Chemistry, 88 (11), 1860–1869. doi:10.1134/s1070427215011018x
  21. Karakurkchi, A. V., Ved’, M. V., Yermolenko, I. Y., Sakhnenko, N. D. (2016). Electrochemical deposition of Fe–Mo–W alloy coatings from citrate electrolyte. Surface Engineering and Applied Electrochemistry, 52 (1), 43–49. doi:10.3103/s1068375516010087
  22. Ved’, M. V., Sakhnenko, M. D., Bohoyavlens’ka, O. V., Nenastina, T. O. (2008). Modeling of the surface treatment of passive metals. Materials Science, 44 (1), 79–86. doi:10.1007/s11003-008-9046-6
  23. Ved, M., Glushkova, M., Sakhnenko, N. (2013). Catalytic properties of binary and ternary alloys based on silver. Functional Materials, 20 (1), 87–91. doi:10.15407/fm20.01.087
  24. Yar-Mukhamedova, G., Ved, M., Sakhnenko, N., Karakurkchi, A., Yermolenko, I. (2016). Iron binary and ternary coatings with molybdenum and tungsten. Applied Surface Science, 383, 346–352. doi:10.1016/j.apsusc.2016.04.046
  25. Karakurkchi, A. V., Ved', M. V., Sakhnenko, N. D., Yermolenko, I. Yu., Zyubanova, S. I., Kolupayeva, Z. I. (2015). Functional properties of multicomponent galvanic alloys of iron with molybdenum and tungsten. Functional Materials, 22 (2), 181–187. doi:10.15407/fm22.02.181
  26. Ved’, M. V., Sakhnenko, M. D., Karakurkchi, H. V., Ermolenko, I. Y., Fomina, L. P. (2016). Functional Properties of Fe−Mo and Fe−Mo−W Galvanic Alloys. Materials Science, 51 (5), 701–710. doi:10.1007/s11003-016-9893-5
  27. Sakhnenko, N. D., Ved’, M. V., Karakurkchi, A. V. (2013). Electrodeposition of the iron-molybdenum alloys. Issues of Chemistry and Chemical Technology, 4, 178‒182.
  28. Ved’, M. V., Sakhnenko, N. D., Karakurkchi, A. V., Yermolenko, I. Yu. (2015). Electroplating and functional properties of Fe-Mo and Fe-Mo-W coatings. Issues of Chemistry and Chemical Technology, 5-6 (98), 53–60.

Published

2017-01-31

How to Cite

Каракуркчи, А. В. (2017). A study of formation peculiarities and properties of iron coatings with refractory metals on gray cast iron SCH18. Technology Audit and Production Reserves, 1(3(33), 19–28. https://doi.org/10.15587/2312-8372.2017.93546

Issue

Section

Chemical and Technological Systems: Original Research