Simulation of the collection process in a cyclone apparatus with the film formation

Authors

  • Volodymyr Novodvorskyi National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute” Peremohy ave., 37, Kyiv, Ukraine, 03056, Ukraine
  • Andrii Stepaniuk National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute” Peremohy ave., 37, Kyiv, Ukraine, 03056, Ukraine https://orcid.org/0000-0001-7626-5572
  • Ruslan Kychak National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute” Peremohy ave., 37, Kyiv, Ukraine, 03056, Ukraine https://orcid.org/0000-0003-4292-3295

DOI:

https://doi.org/10.15587/2313-8416.2019.156427

Keywords:

dust collector, polydisperse dust, apparatus, air purification, cyclone, separator, solid particle

Abstract

The proposed cyclone significantly increases the efficiency of the dust-collecting of the composite contamination, which consists of the solid particles and the water vapor, and contributes to decreasing of temperature in the apparatus and the physical and mathematical models of collection in the cyclone are selected and solved. A literary review is carried out and it is determined that it was previously investigated and that the authors did not investigate dust collection. Dust samples were collected and the fractional composition was determined

Author Biographies

Volodymyr Novodvorskyi, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute” Peremohy ave., 37, Kyiv, Ukraine, 03056

Department of Machines and Apparatus of Chemical and Oil Refinery Productions

Andrii Stepaniuk, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute” Peremohy ave., 37, Kyiv, Ukraine, 03056

PhD, Associate Professor

Department of Machines and Apparatus of Chemical and Oil Refinery Productions

Ruslan Kychak, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute” Peremohy ave., 37, Kyiv, Ukraine, 03056

Postgraduate student

Department of Machines and Apparatus of Chemical and Oil Refinery Productions

References

Batluk, V. V., Batluk, V. A., Basov, M. V. (2009). Stvorennia pylovlovliuvachiv dlia polidyspersnoho pylu. Okhorona pratsi, 2 (16), 181–187.

Koshkarev, S. A., Azarov, V. N. (2015). Evaluation of wet dust separator effectiveness in the dedusting of emissions from expanded clay kiln. Magazine of Civil Engineering, 2, 18–32. doi: http://doi.org/10.5862/mce.54.3

Aslamova, V. S., Zhabey, A. A. (2010). Avtomatizirovannaya sistema issledovaniya tsiklonov i skrubberov. Izvestiya Tomskogo politekhnicheskogo universiteta. Energetika, 316 (4), 71–76.

Kushchenko, O. V. (2003). Pidvyshchennia efektyvnosti system okholodzhennia tiahovoho elektroustatkuvannia lokomotyviv udoskonalenniam povitroochyshchuvachiv. Luhansk, 24.

Kuts, V. P. (2015). Naukovo-praktychni osnovy stvorennia vysokoefektyvnoho pyloochysnoho obladnannia kombinovanoi dii. Lviv, 40.

Wan, G., Sun, G., Xue, X., Shi, M. (2008). Solids concentration simulation of different size particles in a cyclone separator. Powder Technology, 183 (1), 94–104. doi: http://doi.org/10.1016/j.powtec.2007.11.019

Wang, S., Li, H., Wang, R., Wang, X., Tian, R., Sun, Q. (2019). Effect of the inlet angle on the performance of a cyclone separator using CFD-DEM. Advanced Powder Technology, 30 (2), 227–239. doi: http://doi.org/10.1016/j.apt.2018.10.027

Novodvors'kiy, V. V., Stepanyuk, A. R. (2018). Pat. UA. Tsiklon. No. u201807571; declareted: 06.07.2018.

Novodvorskyi, V., Stepaniuk, A. (2018). Simulation of the collecting process in a cyclone apparatus of a new design. ScienceRise, 10, 33–36. doi: http://doi.org/10.15587/2313-8416.2018.146844

Shved, M. P., Stepaniuk, A. R. (2017). Doslidzhennia reolohichnykh vlastyvostei rozchyniv polimeriv. Kyiv: KPI im. Ihoria Sikorskoho, 17.

Published

2019-02-12

Issue

Section

Technical Sciences