Overview of methods and means of implementation of information and measuring components cyber-physical systems for electromagnetic probing
DOI:
https://doi.org/10.15587/2706-5448.2022.260245Keywords:
eddy current method, phase shift measurement, harmonic signal, low frequencies, threshold sensitivityAbstract
The object of research is cyber-physical systems for the study of inhomogeneous environments, in particular, such as land and water depths, in order to find in them the leading bodies. One of the most problematic places in the creation of such systems is a highly sensitive meter of small phase shifts with a low sensitivity threshold.
During the study, a review of methods for achieving a low threshold of sensitivity to phase shift. The main one is the method of converting the phase shift into the amplitude modulation coefficient. The implementation of the method is based on the sum-difference transformation with the preliminary introduction of the quadrature phase shift between the signals. The results concerning the methods of solving the following problems are obtained:
– increasing the temperature stability of the quadrature phase shifter;
– reducing the non-identity of the transmission coefficients of the sumo-difference scheme channels;
– allocation of the amplitude of the amplitude-phase-modulated signal at low ratios of the frequencies of the input signals and switching.
The first problem is partially solved by dividing the quadrature phase shifter into two equal halves, placed in different channels, with approximately the same phase temperature coefficients. The second problem is also solved by manual calibration before measurement. The most difficult task is to extract the bypass from the amplitude-phase-modulated signal, in which the carrier frequency is only several times greater than the bypass. The difficulty is that the detection produces combinational frequencies due to phase modulation. Therefore, it is difficult to separate them. Several methods of allocating the bypass, if the frequency of the input signals is fixed, are considered. This allows to get the sensitivity threshold
(1·10–4÷3·10–5) of advice. Reducing the operating frequency of the signals increases the depth of research, but increases the impact of flicker noise. The minimum frequency is 10 Hz. Therefore, these methods are not suitable for frequencies of Hz units. Methods to reduce the impact of flicker noise will be considered in another paper.
References
- Håkansson, A., Saad, A., Anand, A., Gjærum, V., Robinson, H., Seel, K. (2021). Robust Reasoning for Autonomous Cyber-Physical Systems in Dynamic Environments. Procedia Computer Science, 192, 3966–3978. doi: http://doi.org/10.1016/j.procs.2021.09.171
- Lu, B.-N., Lähde, T. A., Lee, D., Meißner, U.-G. (2016). Precise determination of lattice phase shifts and mixing angles. Physics Letters B, 760, 309–313. doi: http://doi.org/10.1016/j.physletb.2016.06.081
- Lei, H., Huang, Y., Jiang, L., Gao, G., Zhang, J., Wu, P. (2022). Research on Fourier and Prony analysis algorithm of inter-harmonic in power system. Energy Reports, 8, 728–737. doi: http://doi.org/10.1016/j.egyr.2022.02.204
- Gula, І. V. (2011). Rozrobka metodu vimіriuvannia fazovikh zsuvіv signalіv. Vіsnik Khmelnitckogo natcіonalnogo unіversitetu. Tekhnіchnі nauki, 5, 159–161.
- Wu, Z., Guo, W., Zhang, Q. (2022). Two-frequency phase-shifting method vs. Gray-coded-based method in dynamic fringe projection profilometry: A comparative review. Optics and Lasers in Engineering, 153, 106995. doi: http://doi.org/10.1016/j.optlaseng.2022.106995
- Pozar, D. M. (2012). Microwave Engineering. Wiley, 752.
- Behnam, H., Ohtsuki, S., Tanaka, M. (1998). Phase correction on ultrasound speed measurement. Journal of the Acoustical Society of Japan (E), 19 (2), 141–150. doi: http://doi.org/10.1250/ast.19.141
- Lameko, A. L. (2019). Variational method of measuring angular phase difference. Tekhnichna Elektrodynamika, 2, 88–92. doi: http://doi.org/10.15407/techned2019.02.088
- Kondratov, V. T. (1984). Algoritmicheskie metody izmereniia mgnovennykh znachenii fazovogo sdviga infranizkochastotnykh signalov. Kyiv, 40.
- Buchma, I. M., Vzhushchak, M. (2003). Vplyv fliker-shumu v trakti nesuchoi chastoty nyzkochastotnoho kanalu tovshchynomira stalevykh lystovykh konstruktsii. Metody i prylady kontroliu yakosti, 10, 24–27.
- Miziuk, L. Ia., Podzharii, V. M., Protc, R. V. (1971). Izmerenie invariantov magnitnogo polia pri eletrorazvedke. Kyiv: Naukova dumka, 231.
- Buchma, I. (2017). Measurement of Phase Shift between the harmonic signals using binary sampling. Computer Printing Technologies, 1 (37), 78–91.
- Skripnik, Iu. A. (1971). Metody vydeleniia izmeritelnoi informatcii iz garmonicheskikh signalov. Kyiv: Naukova dumka, 276.
- Skripnik, Iu. A., Nizhenskii, A. D. (1964). O vybore chastoty pitaniia avtomaticheskogo kvaziuravnoveshennogo mosta s differentcialnym indikatorom. Izvestiia vuzov. Priborostroenie, 5, 14–22.
- Buchma, I. M. (2008). Zasoby vymiriuvannia induktyvnoi elektrorozvidky ta vykhrostrumovoi diahnostyky. Lviv: Lvivska politekhnika, 294.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2022 Ihor Buchma, Mykhailo Voichenko
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.
