Experimental investigation of liquid-vapor ejector with conical mixing chamber

Authors

DOI:

https://doi.org/10.15587/2312-8372.2016.75345

Keywords:

vapor-liquid ejector, conical mixing chamber, experimental investigation, exergy effectiveness

Abstract

The article is devoted the design of working process of liquid-vapor ejector of a vacuum unit with conical mixing chamber, working on principle of stream thermocompression, research of influence of thermodynamic parameters and descriptions of active and passive streams on the process of mixing with the purpose of achievement of most vacuum unit efficiency.

The main content of the article is study the nature of passive mixing flows with different thermodynamic properties on the geometric parameters of the mixing chamber.

Experimental study of liquid-vapor ejector with conical mixing chamber on a transparent model allowed to confirm the mechanism of the working process at pressures below atmospheric pressure, namely the boiling of metastable superheated liquid, characterized by the presence of three critical sections expiry of expanding the channels to the definition section of flow separation from the walls of the channel and its position relative to the nozzle exit of active flow. Also the nature of the mixing process in the chambers of conical shape is investigated. It allows establishing maximum efficiency by optimizing the flow of liquid-vapor ejector with conical mixing chamber.

The estimation of the appropriateness of units on the basis of LVE in vacuum systems through a comparative exergy analysis of basic and alternative schemes offered by the method of J. Tsatsaronis.

Author Biographies

Sergii Sharapov, Sumy State University, Rimsky-Korsakov 2, Sumy, 40007

Assistant

Department of Technical Thermophysics

Vyacheslav Arsenyev, Sumy State University, Rimsky-Korsakov 2, Sumy, 40007

Candidate of Technical Sciences, Professor

Department of Technical Thermophysics

Viktor Kozin, Sumy State University, Rimsky-Korsakov 2, Sumy, 40007

Candidate of Technical Sciences

Department of Technical Thermophysics

References

  1. Marchenko, V. N., Osipov, V. A., Prokopov, M. G., Sharapov, S. O. (2009). Principle of stream thermocompression: conception of energetic efficiency and prospect of realization is in small heat energetic. MOTROL – Motoryzacja i Energetyka Rolnictwa, 11A, 70–76.
  2. Tsiklauri, G. V., Danilin, B. C., Selesnev, L. I. (1973). Adiabatnye dvuhfasnye techeniia. Moscow: Atomisdat, 448.
  3. Sokolov, E. Ya., Singer, N. M. (1989). Struinye apparaty. Moscow: Energoatomisdat, 352.
  4. Efimochkin, G. I., Korennov, B. E. (1976). Issledovanie i vybor vodostruinyh ezhektorov s udlinennoi kameroi smeshcheniia. Elektricheskie stantsii, 4, 46–49.
  5. Vasil'ev, Yu. N., Gladkov, E. P. (1971). Eksperimental'noe issledovanie vakuumnogo vodovosdushchnogo ezhektora s mnogostvol'nym soplom. Lopatochnye mashchiny i struinye apparaty, 5, 262–306.
  6. Korennov, B. E. (1977). Rabochii protsess v gasozhidkostnom ezhektore. Teploenergetika, 1, 59–65.
  7. Vasil'ev, Yu. N. (1961). Nekotorye svoistva gasovyh ezhektorov so sverhsvukovym diffusorom, imeiushim gorlovinu. Sbornik rabot po issledovaniiu sverhsvukovyh gasovyh ezhektorov. TsAGI im. prof. N. E. Zhukovskogo, 235–260.
  8. Dem'ianova, L. A. (1999). Analiticheskii raschet harakteristik struinogo apparata pri otkachke gasozhidkostnyh smesei. Neftepromyslovoe delo, 5, 39–44.
  9. Cunningham, R. G. (1954, July). The Jet Pump as a Lubrication Oil Scavenge Pump for Aircraft Engines. W. A. D. C. Report 55-143, 130.
  10. Sharapov, S. O. (2011). Objectives of Experimental Research Work the Liquid – Steam – Jet Ejector in the Vacuum Mode and the Technical Content. Visnyk Sumskoho derzhavnoho universytetu. Seriia Tekhnichni nauky, 1, 51–57.
  11. Sharapov, S., Arsenyev, V., Protsenko, M. (2013). The use of liquid-vapor ejector in vacuum systems. Compressors 2013: 8th International Conference on Compressors and Coolants, Vol. 4. France/Slovakia. Available: http://www.iifiir.org/clientBookline/service/reference.asp?INSTANCE=EXPLOITATION&OUTPUT=PORTAL&DOCID=IFD_REFDOC_0008650&DOCBASE=IFD_REFDOC_EN&SETLANGUAGE=EN

Downloads

Published

2016-07-26

How to Cite

Sharapov, S., Arsenyev, V., & Kozin, V. (2016). Experimental investigation of liquid-vapor ejector with conical mixing chamber. Technology Audit and Production Reserves, 4(1(30), 50–55. https://doi.org/10.15587/2312-8372.2016.75345

Issue

Vol. 4 No. 1(30) (2016): Mechanical engineering and machine building. Energy, energy-saving technologies and equipment

Section

Energy, energy-saving technologies and equipment

License

Copyright (c) 2016 Viktor Kozin, Sergii Sharapov, Vyacheslav Arsenyev

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.