Development of simulation model of centrifugal blowers for gas pumping unit taking into account bypass
DOI:
https://doi.org/10.15587/2312-8372.2016.79919Keywords:
surge, centrifugal blower, simulation, anti-surge valve, control, speedAbstract
After a thorough analysis of failures in the compressor stations that operate centrifugal blowers Ц-16, which are the object of this research, it was found that a significant proportion of failures are the failures caused by surge phenomenon (25 %). One way to improve reliability is to introduce of high-speed multi-parametric and fuzzy controllers in a system structure that will prevent a surge.
Gas dynamic characteristics of a centrifugal blower are approximated by regression model as a quintic polynomial. Characteristics of anti-blowing valve were approximated by a quintic polynomial, and characteristics of the actuator – derived from an active experiment, where rotation angle of the actuator output shaft was fixed by position sensor for abrupt change of the control signal. Moore-Greitzer model was used for describing of blower dynamics.
Based on the above parameters obtained from the studies, simulation model of centrifugal blower of compressor unit that synthesized in the software Matlab will make it possible to simulate surge phenomenon.
Based on the developed simulation model of automatic anti-surge control (ASC) system, multi-parametric and fuzzy controllers were synthesized. They were shown high rates of ASC speed.
References
- Abed, E. H., Houpt, P. K., Hosny, W. M. (1993). Bifurcation Analysis of Surge and Rotating Stall in Axial Flow Compressors. Journal of Turbomachinery, Vol. 115, № 4, 817–824. doi:10.1115/1.2929320
- Gravdahl, J. T. (1998). Modeling and Control of surge and rotating stall in compressor. Norway, Trondheim: Norwegian University of Science and Technology, 152. Available: http://folk.ntnu.no/tomgra/papers/thesis.pdf
- Greitzer, E. (1976). Surging and rotating stall in axial compressors. Experimental results and comparison with theory. Energy systems and machines, 73-96.
- Moore, F. K. (1984). A Theory of Rotating Stall of Multistage Axial Compressors: Part I – Small Disturbances. Journal of Engineering for Gas Turbines and Power, Vol. 106, № 2, 313–320. doi:10.1115/1.3239565
- Moore, F. K., Greitzer, E. M. (1986). A Theory of Post-Stall Transients in Axial Compression Systems: Part I – Development of Equations. Journal of Engineering for Gas Turbines and Power, Vol. 108, № 1, 68–76. doi:10.1115/1.3239887
- Greitzer, E. M. (1976). Surge and Rotating Stall in Axial Flow Compressors – Part I: Theoretical Compression System Model. Journal of Engineering for Power, Vol. 98, № 2, 190–198. doi:10.1115/1.3446138
- Kozakiewicz, V. (1974). Self-oscillations (surge) in the compressors. Moscow: Mashinostroenie, 264.
- Tsebenko, M., Sadovоy, A., Volyansky, R. (2010). Mathematical models eliminate the surge in a centrifugal compressor. Bulletin of KSU n.a. M. Ostohradskiy, 4 (63), 167–169.
- Sadovоy, A., Tsabenko, M., Nagorny, D. (2014). Dynamic model of electromechanical system «centrifugal compressor – engine». Bulletin of NTU «KhPI», 15 (1058), 134–140.
- Wolanska, L. (2005). Dynamics loss of gas-dynamic resistance in the axial compressor. Bulletin of NAU, 3, 104–107.
- Savchenko, E., Sidorets, А., Sidorets, І. (2009). Anti-surge control valve centrifugal blower natural gas. Bulletin of Sum SU, 4, 83–89.
- Sementsov, G., Lagoyda, A. (2014). Antisurge management of gas pumping units using polyvalent controllers. Eastern-European Journal Of Enterprise Technologies, 4(8(70)), 34–39. doi:10.15587/1729-4061.2014.26260
- Sementsov, G., Lagoyda, А. (2015). Improvement optimal control of gas pumping units on the basis of multi regulators. Oil and Gas Energy, 1 (23), 61–68.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2016 Андрій Іванович Лагойда, Георгій Никифорович Семенцов, Мирослав Іванович Когутяк
![Creative Commons License](http://i.creativecommons.org/l/by/4.0/88x31.png)
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.