Equivalent transformations of geometric models

Authors

  • Інна Володимирівна Хоменко The institute of mathematical machines and systems problems NASU Glushkov Ave, 42, Kyiv, Ukraine, 03680, Ukraine

DOI:

https://doi.org/10.15587/1729-4061.2013.9153

Keywords:

automation of the learning process, engineering graphics, computer-aided design, data presentation and knowledge, geometric simulation language.

Abstract

The use of information technology is one of the few technologically and economically profitable ways of improvement of the production efficiency. The main tool of automation of design and technological units are computer- aided design systems. However, the CAD is not only the software, but also qualified personnel, procedures, etc. Most analysts agree on the opinion that the main problem of the introduction of computer systems in production is a personnel problem. That is why, the problems of development and implementation of effective information technologies in education acquire more importance. The article considers the questions that arise in the design of systems based on knowledge: data presentation and knowledge. The languages of knowledge representation were analyzed. Taking into account the drawbacks of the existing languages, a special language of representation of geometric models was developed in the system for automated training of disciplines, rich in engineering graphics.

Author Biography

Інна Володимирівна Хоменко, The institute of mathematical machines and systems problems NASU Glushkov Ave, 42, Kyiv, Ukraine, 03680

Graduate student of the third year of training

References

  1. Гаврилова, Т. А. Базы знаний интеллектуальных систем [Текст] / Т. А. Гаврилова, В. Ф. Хорошевский – СПб: Питер, 2000. – 384 с.
  2. Атанов, Г. А. Обучение и искусственный интеллект или основы современной дидактики высшей школы [Текст] / Г. А. Атанов, И. Н. Пустынникова – Донецк: Изд-во ДОУ, 2002. – 504 с.
  3. Hughes, J. Why Functional Programming Matters [Текст] / J. Hughes – The Computer Journal, 1989, Vol. 32, № 2, pp. 98–107.
  4. Хоггер, К. Введение в логическое программирование: Пер. с англ. [Текст] / К. Хоггер – М.: Мир, 1988. – 348 с.
  5. Аверин, А. И. Алгоритмы параллельной унификации [Текст] А. И. Аверин, В.Н. Вагин // Тр. международных науч.-техн. конф. "Интеллектуальные системы (IEEE AIS' 03)" и "Интеллектуальные САПР" (CAD-2003) – М.: Физматлит, 2003, Т. 1. – С. 153-159.

Published

2013-02-05

How to Cite

Хоменко, І. В. (2013). Equivalent transformations of geometric models. Eastern-European Journal of Enterprise Technologies, 1(4(61), 34–37. https://doi.org/10.15587/1729-4061.2013.9153

Issue

Section

Mathematics and Cybernetics - applied aspects