Investigation of composition and structure of tripoliphosphate coating on low carbon steel
DOI:
https://doi.org/10.15587/1729-4061.2017.96572Keywords:
sodium tripolyphosphate, iron (III) tripolyphosphate, precipitate, coating, protective properties, matrix structure, chemical synthesisAbstract
The hypothesis on the matrix (composite) structure of the iron (III) tripolyphosphate precipitate and polyphosphate coatings on the steel substrate has been justified experimentally. According to the hypothesis, that iron (III) tripolyphosphate acts as a matrix forming agent while water-soluble sodium tripolyphosphate corrosion inhibitor is a filler.
Be means of the chemical synthesis method, it has been demonstrated that the chemical basis of the coating formed on the steel surface in the STPP solution is iron (III) tripolyphosphate.
It has been established that the composite structure of tripolyphosphate coatings and precipitates is determined by the nature of iron (III) tripolyphosphate.
The conducted investigation on the composition of the iron (III) tripolyphosphate precipitate and tripolyphosphate coating on steel, using the gravimetric method with washing have proved the presence of STPP. The results of X-ray spectral analysis have revealed that STPP in the structure of composite coating is situated not only as a filler inside the matrix but also as an additional layer on its surface.
The chemical protection mechanism of the tripolyphosphate coating on steel in atmospheric conditions has been justified.
The acquired knowledge would expand the theoretical and practical concept of the structure and properties of tripolyphosphate coatings on the steel substrate and their protection mechanism in conditions of atmospheric corrosion. The application of new knowledge in researches aimed at the development of ecologically safe methods of tripolyphosphate coating deposition with estimated complex of properties, would increase their efficiency.References
- Grigoryan, N. S., Akimova, E. F., Vagramyan, T. A. (2008). Fosfatirovanie. Moscow: Globus, 144.
- Akol'zin, A. P. (1989). Protivokorrozionnaya zashchita stali plenkoobrazova-telyami. Moscow: Metallurgiya, 192.
- Lipkin, Ya. N., Shtan'ko, V. M. (1974). Himicheskaya i ehlektrohimicheskaya obrabotka stal'nyh trub. Moscow: Metallurgiya, 216.
- Cheremysinova, A. O., Panasenko, S. P. (2010). Pat. No. 94340 UA. Mastylo dlya prokatky stal'nykh bezshovnykh trub ta sposib yoho oderzhannya. MPK S 10 M 103/00, S 10 M 177/00. No. a201001874; declareted: 22.02.2010; published: 26.04.2011, Bul. No. 8, 3.
- Abdalla, K., Rahmat, A., Azizan, A. (2012). The Effect of pH on Zinc Phosphate Coating Morphology and its Corrosion Resistance on Mild Steel. Advanced Materials Research, 626, 569–574. doi: 10.4028/www.scientific.net/amr.626.569
- Tumbaleva, Y., Ivanova, D., Fachikov, L. (2011). Effect of the P2O5:NO3 – retio on the zink phosphate coating formation. Journal of the University of Chemical Technology and Metallurgy, 46 (4), 357–362.
- Kuznecov, Yu. I. (2001). Ingibitory korrozii v konversionnyh pokrytiyah IIΙ. Zashchita metallov ot korrozii, 37 (2), 119–125.
- Piani, L., Papo, A. (2013). Sodium Tripolyphosphate and Polyphosphate as Dispersing Agents for Alumina Suspensions: Rheological Characterization. Journal of Engineering, 2013, 1–4. doi: 10.1155/2013/930832
- Ait-Salah, A., Ramana, C. V., Gendron, F., Morhange, J. F., Mauger, A., Zaghib, K., Julien, C. (2007). Synthesis, Structure and Electrochemical Properties of LiFe2P3O10 Synthesized by Wet Chemistry. ECS Transactions, 3 (36), 95–100. doi: 10.1149/1.2795110
- Rozenfel'd, I. L. (1977). Ingibitory korrozii. Mosocw: Himiya, 352.
- Ltifi, M., Guefrech, A., Mounanga, P. (2011). Effects of sodium tripolyphosphate addition on early-age physico-chemical properties of cement pastes. Procedia Engineering, 10, 1457–1462. doi: 10.1016/j.proeng.2011.04.242
- Deya, M., Di Sarli, A. R., del Amo, B., Romagnoli, R. (2008). Performance of Anticorrosive Coatings Containing Tripolyphosphates in Aggressive Environments. Industrial & Engineering Chemistry Research, 47 (18), 7038–7047. doi: 10.1021/ie071544d
- Deya, M., Vetere, V. F., Romagnoli, R., del Amo, B. (2001). Aluminium tripolyphosphate pigments for anticorrosive paints. Pigment & Resin Technology, 30 (1), 13–24. doi: 10.1108/03699420110364129
- Vetere, V. F., Deya, M. C., Romagnoli, R., Amo, B. (2001). Calcium tripolyphosphate: An anticorrosive pigment for paint. Journal of Coatings Technology, 73 (6), 57–63. doi: 10.1007/bf02698398
- Yanga, Y. F., Scantleburya, J. D., Koroleva, E., Ogawab, O., Tanabeb, H. (2010). A Novel Anti-corrosion Calcium Magnesium Polyphosphate Pigment and Its Performance in Aqueous Solutions on Mild Steel. ECS Transactions, 24 (1), 77–85. doi: 10.1149/1.3453608
- Yanga, Y. F., Scantlebury, J. D., Koroleva, E., Ogawa, O., Tanabe, H. (2010). A Novel Anti-corrosion Calcium Magnesium Polyphosphate Pigment and its Performance in Aqueous Solutions on Mild Steel When Coupled to Metallic Zinc. ECS Transactions, 24 (1), 163–168. doi: 10.1149/1.3453615
- Burlov, V. V., Al'cybeeva, A. I., Kuzikova, T. M. (2011). Lokal'naya korroziya oborudovaniya sovremennogo nefte-pererabatyvayushchego zavoda. Izvestiya Sankt – Peterburgskogo gosudarstvennogo tekhnolo-gicheskogo universiteta (tekhnicheskogo universiteta), 11 (37), 92–96.
- Kheireddine, A., Fahim, I. (2013). Sodium tripolyphosphate (STPP) as a novel corrosion inhibitor for mild steel in 1M HCL. Journal of optoelectronics and advanced materials, 15 (5-6), 451–456.
- Yohai, L., Schreiner, W., Valcarce, M. B., Vazquez, M. (2016). Inhibiting Steel Corrosion in Simulated Concrete with Low Phosphate to Chloride Ratios. Journal of The Electrochemical Society, 163 (13), C729–C737. doi: 10.1149/2.0511613jes
- Lee, S.-J., Toan, D. L. H., Chen, Y.-H., Peng, H.-C. (2016). Performance Improvement of Phosphate Coating on Carbon Steel by Cathodic Electrochemical Method. Int. J. Electrochem. Sci., 11, 2306–2316.
- Vlasova, E., Kovalenko, V., Kotok, V., Vlasov, S. (2016). Research of the mechanism of formathion and properties of tripolyphosphate coatingon the steel basis. Eastern-European Journal of Enterprise Technologies, 5 (5 (83)), 33–39. doi: 10.15587/1729-4061.2016.79559
- Vlasova, E. V., Karasik, T. L. (2010). Issledovanie pokrytij, poluchennyh iz vodnyh rastvorov fosfatov. Metallurgicheskaya i gornorudnaya promyshlennost', 5, 89–91.
- Vlasova, E. V., Karasik, T. L., Levko, E. N., Kovalenko, V. L., Lizogub, A. A. (2011). Rolled metal products functional coatings based on alkali metals phosphates. Eastern-European Journal of Enterprise Technologies, 5 (6 (53)), 30–33. Available at: http://journals.uran.ua/eejet/article/view/1244/1146
- Sutchenko, A. S., Vlasova, E. V., Yaroshenko, N. V. (2014). Issledovanie struktury i svojstv sovremennyh mezhoperacionnyh pokrytij. Innovacionnyj potencial miro-voj nauki XXI stoletiya, 61–62.
- Kovalenko, V. L., Kotok, V. A., Sykchin, A. A., Mudryi, I. A., Ananchenko, B. A., Burkov, A. A. et. al. (2016). Nickel hydroxide obtained by high-temperature two-step synthesis as an effective material for supercapacitor applications. Journal of Solid State Electrochemistry, 21 (3), 683–691. doi: 10.1007/s10008-016-3405-2
- Kovalenko, V., Kotok, V., Bolotin, O. (2016). Definition of factors influencing on Ni(OH)2 electrochemical characteristics for supercapacitors. Eastern-European Journal of Enterprise Technologies, 5 (6 (83)), 17–22. doi: 10.15587/1729-4061.2016.79406
- Burmistr, M. V., Boiko, V. S., Lipko, E. O., Gerasimenko, K. O., Gomza, Y. P., Vesnin, R. L. et. al. (2014). Antifriction and Construction Materials Based on Modified Phenol-Formaldehyde Resins Reinforced with Mineral and Synthetic Fibrous Fillers. Mechanics of Composite Materials, 50 (2), 213–222. doi: 10.1007/s11029-014-9408-0
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2017 Elena Vlasova, Vadym Kovalenko, Valerii Kotok, Sergey Vlasov, Irina Sknar, Anna Cheremysinova
![Creative Commons License](http://i.creativecommons.org/l/by/4.0/88x31.png)
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.
A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.