Influence of free space high on boiling heat-transfer intensity on porous structure

Authors

  • Ольга Сергіївна Алексеїк National Technical University "Kyiv Polytechnic Institute" Peremogy av. 37, Kyiv, Ukraine, 03056, Ukraine
  • Володимир Юрійович Кравець National Technical University "Kyiv Polytechnic Institute" Peremogy av. 37, Kyiv, Ukraine, 03056, Ukraine

DOI:

https://doi.org/10.15587/1729-4061.2012.5725

Keywords:

Heat-transfer intensity, boiling, porous structure

Abstract

Characteristics of boiling process on porous structure were investigated. Increasing of surface superheat with decreasing of free space above porous covering was observed. Influence of inclination angle on boiling heat-transfer intensity was determined

Author Biographies

Ольга Сергіївна Алексеїк, National Technical University "Kyiv Polytechnic Institute" Peremogy av. 37, Kyiv, Ukraine, 03056

Post-graduate student

Department of nuclear power plants and engineering thermophysics

Володимир Юрійович Кравець, National Technical University "Kyiv Polytechnic Institute" Peremogy av. 37, Kyiv, Ukraine, 03056

Ph.D., Associate Professor

Department of nuclear power plants and engineering thermophysics

References

  1. Маньковский О.Н. О механизме процесса кипения на затопленных поверхностях с пористым покрытием [Текст] / О.Н. Маньковский, О.Б. Иоффе, Л.Г. Фридгант, А.Р. Толчинский // ИФЖ. – 1976. – Т.30, №2. – С. 310-316
  2. Стырикович М.А. О механизме переноса нелетучих примесей при кипении на поверхностях, покрытых пористими структурами [Текст] / М.А. Стырикович, А.И. Леонтьев, С.П. Малышенко // ТВТ. – 1976. - Т.14. - С. 998 – 1006
  3. Зуйков А.С. Модель процесса концентрирования при кипении в КПС [Текст] / А.С. Зуйков, А.И. Леонтьев, В.С. Полонский и др. – докл. АН СССР, 1978 - Т.241, №3 - С. 579 – 583
  4. Шаповал А.А. Теплообмен при кипении воды и ацетона на поверхностях с металловолокнистыми капиллярно-пористыми покрытиями. Автореферат диссертации на соискание ученой степени кандидата технических наук: 01.04.14 [Текст] / Шаповал А.А. – Киев, Институт технической теплофізики, 1985. – 23 с.
  5. Кичатов Б.В. Кипение жидкости на поверхностях с пористыми покрытиями [Текст] / Б.В. Кичатов, В.М. Поляев // 4 th Minsk International Heat and Mass Transfer Forum.- Minsk, Belarus. - 2000 - Р. 176-188.
  6. Alam M.S. Enhanced boiling of saturated water on copper coated heating tubes [Текст] / Mohammad Siraj Alam, L. Prasad, S.C. Gupta, V.K. Agarwal // Chemical Engineering and Processing Process Intensification. – 2008. – January (Vol. 47, Iss.1). – Р. 159-167
  7. Li Ch. Evaporation/Boiling in Thin Capillary Wicks (I) – Wick Thickness Effects [Текст] / Chen Li, G. P. Peterson, Yaxiong Wang // Journal of Heat Transfer. - 2006 – December (Vol. 128, Iss. 12) – Р. 1312-1320
  8. Hanlon M. A. Evaporation Heat Transfer in Sintered Porous Media [Текст] / M. A. Hanlon, H. B. Ma // Journal of Heat Transfer. – 2003. – August (Vol. 125 , Iss. 8) – Р. 644-652
  9. Фрідріхсон Ю.В. Вплив тиску і характеристик металоволокнистих покриттів на теплообмін при кипінні рідин у великому об’ємі. Автореферат дисертації на здобуття наукового ступеня кандидата технічних наук: 05.14.05 [Текст] / Ю.В. Фрідріхсон – Київ, КПІ 1995. – 16 с.
  10. Li Ch. Evaporation/Boiling in Thin Capillary Wicks (II) – Effects of Volumetric Porosity and Mesh Size [Текст] / Chen Li, G. P. Peterson // Journal of Heat Transfer. – 2006. – December (Vol. 128, Iss. 12) – Р. 1320-1328
  11. Das A.K. Performance of different structured surfaces in nucleate pool boiling [Текст] / A.K. Das, P.K. Das, P. Saha // Applied Thermal Engineering. – 2009. – December (Vol. 29, Iss. 17-18) – Р. 3643-3653
  12. Верховский В.В. Внутренние характеристики процесса и теплообмен при кипении хладагентов на поверхностях с исскуственными центрами парообразования [Текст] / В.В. Верховский, Г.Н. Данилова, А.В. Тихонов // In: Proc. 4th Minsk International Heat and Mass Transfer Forum. - Minsk, Belarus. – 2000. – Р. 168-175
  13. Arik M. Enhancement of pool boiling critical heat flux in dielectric liquids by microporous coatings [Текст] / Mehmet Arik, Avram Bar-Cohen, Seung Mun You // International Journal of Heat and Mass Transfer. – 2007. – March (Vol. 50, Iss. 5-6) – Р. 997-1009
  14. Кузма-Китча Ю.А. Улучшение характеристик элементов парогенерирующей техники путем интенсификации теплообмена [Текст] / Ю.А. Кузма-Китча, А.С. Комендантов, Г. Барч // In: Proc. 4th Minsk International Heat and Mass Transfer Forum. – Minsk, Belarus. – 2000. – Р. 215-222
  15. Sarwar M.S. Subcooled flow boiling CHF enhancement with porous surface coatings [Текст] / Mohammad Sohail Sarwar, Yong Hoon Jeong, Soon Heung Chang // International Journal of Heat and Mass Transfer. – 2007. – August (Vol. 50, Iss. 17-18) – Р. 3649-3657
  16. Forrest E. Augmentation of nucleate boiling heat transfer and critical heat flux using nanoparticle thin-film coatings [Текст] / E. Forrest, E. Williamson, J. Buongiorno, L-W Hu, M. Rubner, R. Cohen // International Journal of Heat and Mass Transfer. – 2010. – January (Vol. 53, Iss. 1-3) – Р. 58-67
  17. Алексеик О.С. Интенсивность теплоотдачи при кипении на поверхности малого размера [Текст] / О.С. Алексеик, В.Ю. Кравец, И.А. Копчевская // Технология и конструирование в электронной аппаратуре. – 2012. – №1 – С.49-53

Downloads

Published

2012-08-20

How to Cite

Алексеїк, О. С., & Кравець, В. Ю. (2012). Influence of free space high on boiling heat-transfer intensity on porous structure. Eastern-European Journal of Enterprise Technologies, 4(8(58), 24–27. https://doi.org/10.15587/1729-4061.2012.5725

Issue

Vol. 4 No. 8(58) (2012): Energy-saving technologies and equipment

Section

Energy-saving technologies and equipment

License

Copyright (c) 2014 Ольга Сергіївна Алексеїк, Володимир Юрійович Кравець

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.