Investigation of heat exchange in a blown dense layer of granular materials
DOI:
https://doi.org/10.15587/1729-4061.2017.112217Keywords:
heat exchange, granular material, moving layer, stationary, gas flow, temperature curvesAbstract
Experimental studies of heat exchange between a dense layer of granular material and a stream of heated air have been carried out. As a granular material, claydite and gravel were used in a moving and a stationary layer. Temperature curves were obtained for the air flow and the solid component at the inlet and outlet of the installation. The shape of the curves indicates presence of two distinct zones with different heating rates. It was stated that it is expedient to set the heating period in the heat accumulators with a stationary bed within the first period which is characterized by a high heating rate. When calculating duration of the heating period, it is rational to take the value of the final material temperature 10‒15 % lower than the temperature of the heating air at the inlet. It was established that the coefficient of intercomponent heat exchange depends on the gas velocity, the velocity of the bed motion, the gas temperature at the input to the installation and the process duration. It was found that the curves of the dependence of the coefficients of intercomponent heat exchange on the process duration are described by a sigma function.
Intensity of heat transfer for a moving layer in the investigated region was commensurable or somewhat higher than that for a stationary layer. It was shown that claydite is the preferred material for a granular packing. The time to onset of a stationary mode for a moving claydite layer was reduced by 2.4 times in comparison with gravel layer and by 2.2 times for a stationary layer.
References
- Kilkovský, B., Jegla, Z. (2016). Preliminary Design and Analysis of Regenerative Heat Exchanger. Сhemical engineering transactions, 52, 655–660.
- Sit, M. L., Juravliov, A. A., Doroshenko, A. V., Goncharenko, V. A. (2016). Energy Supply System for Industrial Poultry Houses. Problemele energeticii regionale, 1 (30), 89–100.
- Vasil'ev, V. A., Kameneckiĭ, K. K. (2010). Eksperimental'noe issledovanie regenerativnogo teploobmennika i analiz teplovyh processov. Holodil'naya tekhnika i kondicionirovanie, 2, 22–33.
- Ding, Y., He, Y., Cong, N. T., Yang, W., Chen, H. (2008). Hydrodynamics and heat transfer of gas–solid two-phase mixtures flowing through packed beds – a review. Progress in Natural Science, 18 (10), 1185–1196. doi: 10.1016/j.pnsc.2008.03.023
- Chandratilleke, T. T., Nadim, N., Batsioudis, K. (2016). Thermal performance and optimisation of a granular-bed heat recuperator. Material of12th International Conference on Heat Transfer, Fluid Mechanics and Thermodynamics, 183–187.
- Wołkowycki, G. (2015). Experimental Results on the Fixed Matrix Regenerator Effectiveness for a Glass Stove Furnace. Heat Transfer Engineering, 37 (6), 591–602. doi: 10.1080/01457632.2015.1060780
- Snider, D. M. (2007). Three fundamental granular flow experiments and CPFD predictions. Powder Technology, 176 (1), 36–46. doi: 10.1016/j.powtec.2007.01.032
- Medvedev, V. B., Mizonov, V. E., Elin, N. N., Subbotin, V. I. (2008). Yacheechnaya model' poperechno-potochnogo teploobmena mezhdu sypuchim materialom i gazom. Himiya i him. Tekhnologiya, 53 (5), 135–137.
- Solodkaya, A. V., Boshkova, I. L. (2017). Matematicheskoe opisanie processa teploobmena mezhdu potokami gaza i dispersnogo materiala. Zhurn. Holodil'naya tekhnika i tekhnologiya, 53 (2), 39–43.
- Cardona, A., Storti, M., Zuppa, C. (2008). Numerical simulation of packed bed heat regenerators. Mecánica Computacional, Argentina, 27, 1601–1618.
- Adeyanju, A. A., Manohar, K. (2009). Theoretical and Experimental Investigation of Heat Transfer in Packed Beds. Research Journal of Applied Sciences, 4 (5), 166–177.
- Efimov, A. V., Goncharenko, L. V., Cymbal, K. E., Esipenko, T. A. (2003). Vybor kriterial'nyh uravneniy dlya rascheta teploobmena v kondensacionnyh teploobmennyh apparatah s promezhutochnym sharoobraznym teplonositelem. Vestnik NTU «KhPI», 3, 24–31.
- Ganzha, V. L. (2007). Osnovy effektivnogo ispol'zovaniya energoresursov. Teoriya i praktika energosberezheniya. Minsk: Belorusskaya nauka, 451.
- Arvaniti, E. C., Juenger, M. C. G., Bernal, S. A., Duchesne, J., Courard, L., Leroy, S. et. al. (2014). Determination of particle size, surface area, and shape of supplementary cementitious materials by different techniques. Materials and Structures, 48 (11), 3687–3701. doi: 10.1617/s11527-014-0431-3
- Boshkova, I. L., Solodkaya, A. V. (2016). Investigation of heat exchange efficiency in the heat exchanger waste heat recovery with granular nozzle. Material of 3rd International Conference Energy of Moldova – 2016: Regional Aspects of Development. Chishinau, 373–377.
- Gorbis, Z. R. (1970). Teploobmen i gidromekhanika dispersnyh skvoznyh potokov. Moscow: Energiya, 424.
- Duran, J., Gennes, P. G., Reisinger, A. (2012). Sands, Powders, and Grains: An Introduction to the Physics of Granular Materials. New York: Springer-Verlag, 214.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2017 Antonina Solodka, Natalya Volgusheva, Irina Boshkova, Alexandr Titlov, Andrey Rozhentsev
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.
A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.
