Development of energy-saving technology for maintaining the functioning of heat pump power supply

Authors

DOI:

https://doi.org/10.15587/1729-4061.2018.139473

Keywords:

heat pump system, frequency control, digital control, evaporation pressure, condensation pressure

Abstract

An integrated system of maintaining functioning of heat pump power supply based on prediction of a change of local water temperature was developed. A change in refrigerant vapor flow rate, the number of rotations of the electric motor of the compressor occurs at measuring of the refrigerant temperature at the outlet of the condenser, evaporation pressure, condensation pressure and voltage frequency. Comprehensive mathematic modeling of the heat pump system, based on the integrated system of maintaining soil heat discharge at the level of 8–10 °C was performed. Refrigerant flow rate, compressor motor power, voltage, voltage frequency, the number of rotations of electric motor of the compressor, coefficients of efficiency of a heat pump system for the established levels of functioning were determined. Parameters of convective heat exchange in the condenser, time constants and coefficients of the mathematical models of dynamics of a change in local water temperature, refrigerant flow rate, the number of rotations of the electric motor of the compressor were established. The functional estimation of a change in local water temperature in the range of 35–55 °C within the heating season, refrigerant vapor flow rate, the number of rotations of the electric motor of the compressor was obtained. Determining of the resulting functional information allows makes it possible to obtain the following advancing decisions: to maintain a change in evaporation pressure to change the refrigerant vapor flow rate for digital control; to maintain a change in evaporation pressure to change the refrigerant vapor flow rate and to change voltage frequency on a change of the number of rotations of the electric motor of the compressor for frequency control.

That is why prediction of a change in local water temperature based on measurement of the refrigerant temperature at the outlet of the condenser was proposed. This estimation in the ratio with the measured evaporation pressure is included in analytical determining of refrigerant flow rate and the number of rotations of the electric motor of the compressor. Obtaining such estimation and measurement of frequency voltage makes it possible to make an advancing influence on coordination of functioning of the internal and external circuits of a heat pump system both at digital and frequency control.

Author Biography

Eugene Chaikovskaya, Odessa National Polytechnic University Shevchenka ave., 1, Odessa, Ukraine, 65044

PhD, Associate Professor, Senior Researcher

Department of Theoretical, general and alternative energy

References

  1. Jiang, S. (2017). Air-Source Heat Pump Systems. Handbook of Energy Systems in Green Buildings, 1–44. doi: https://doi.org/10.1007/978-3-662-49088-4_2-1
  2. Rees, S. J. (2016). An introduction to ground-source heat pump technology. Advances in Ground-Source Heat Pump Systems, 1–25. doi: https://doi.org/10.1016/b978-0-08-100311-4.00001-7
  3. Chaikovskaya, E. (2015). Devising an energy saving technology for a biogas plant as a part of the cogeneration system. Eastern-European Journal of Enterprise Technologies, 3 (8 (75)), 44–49. doi: https://doi.org/10.15587/1729-4061.2015.44252
  4. Suzuki, M., Yoneyama, K., Amemiya, S., Oe, M. (2016). Development of a Spiral Type Heat Exchanger for Ground Source Heat Pump System. Energy Procedia, 96, 503–510. doi: https://doi.org/10.1016/j.egypro.2016.09.091
  5. Liu, W., Xu, M. (2017). Research Progress of Pile Heat Exchangers in Ground Source Heat Pump System. Procedia Engineering, 205, 3775–3781. doi: https://doi.org/10.1016/j.proeng.2017.10.141
  6. Chaikovskaya, E. (2016). The development of the method of maintaning the soil discharge in the heat pump energy supply. Technology Audit and Production Reserves, 4 (1 (30)), 33–39. doi: https://doi.org/10.15587/2312-8372.2016.74705
  7. Dincer, I., Rosen, M. A., Ahmadi, P. (2017). Modeling and Optimization of Heat Pump Systems. Optimization of Energy Systems, 183–198. doi: https://doi.org/10.1002/9781118894484.ch6
  8. Underwood, C. P. (2016). Heat pump modelling. Advances in Ground-Source Heat Pump Systems, 387–421. doi: https://doi.org/10.1016/b978-0-08-100311-4.00014-5
  9. Li, Y., Yu, J. (2016). Theoretical analysis on optimal configurations of heat exchanger and compressor in a two-stage compression air source heat pump system. Applied Thermal Engineering, 96, 682–689. doi: https://doi.org/10.1016/j.applthermaleng.2015.11.132
  10. Matuska, T., Sourek, B., Sedlar, J. (2016). Heat Pump System Performance with PV System Adapted Control. Proceedings of EuroSun2016. doi: https://doi.org/10.18086/eurosun.2016.08.06
  11. Yan, G., Bai, T., Yu, J. (2016). Energy and exergy efficiency analysis of solar driven ejector–compressor heat pump cycle. Solar Energy, 125, 243–255. doi: https://doi.org/10.1016/j.solener.2015.12.021
  12. Van Leeuwen, R. P., Gebhardt, I., de Wit, J. B., Smit, G. J. M. (2016). A Predictive Model for Smart Control of a Domestic Heat Pump and Thermal Storage. Proceedings of the 5th International Conference on Smart Cities and Green ICT Systems. doi: https://doi.org/10.5220/0005762201360145
  13. Chaikovskaya, E. E. (2016). Coordination energy production and consumption based on intellectual control heat and mass transfer processes. XV Minsk International Heat and Mass Transfer Forum: Heat and mass transfer processes in the energy and equipment. Energy savings. Minsk, 1–12.
  14. Chaikovska, Y. Y. (2017). Intellectual systems for support of energy systems functioning at level of decision-making. Power engineering: economics, technique, ecology, 3, 114–118. doi: https://doi.org/10.20535/1813-5420.3.2017.117377

Downloads

Published

2018-07-24

How to Cite

Chaikovskaya, E. (2018). Development of energy-saving technology for maintaining the functioning of heat pump power supply. Eastern-European Journal of Enterprise Technologies, 4(8 (94), 13–24. https://doi.org/10.15587/1729-4061.2018.139473

Issue

Vol. 4 No. 8 (94) (2018): Energy-saving technologies and equipment

Section

Energy-saving technologies and equipment

License

Copyright (c) 2018 Eugene Chaikovskaya

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.