Study the kinetics of heterogeneous catalytic oxidation of methane on palladium metal-foil catalysts
DOI:
https://doi.org/10.15587/1729-4061.2013.12274Keywords:
Methane, metal-foil catalyst, heterogeneous catalytic oxidation, ion implantation, rate of reactionAbstract
The article presents the results of the study of the kinetics of heterogeneous catalytic oxidation of methane by oxygen on the developed catalysts, containing oxides of Cr, Ni, Fe, implanted by aluminum nitride, activated with palladium and deposited on a metal-foil carrier made of steel 12X18H10T.
We have developed the technology of metal-foil cellular catalyst, activated with palladium, applying the method of ion implantation. This method is known as the technology of various composites with high wear resistance, corrosion resistance, but it was used little for the catalysts previously.
As the catalyst for the experiment we used the samples with the percentage of palladium concentration 0.07% and 0.15%.
The experimental data were processed with the hypothesis of the mechanism as a kind of power rate equation of type, as well as the sorption type of "Langmuir-Hinshelwood mechanism."
The obtained kinetic equations provide an opportunity to explore according to the full two-phase mathematical model of reactor, the technology of catalytically stabilized combustion of hydrocarbon fuelsReferences
- Giornelli T. Preparation and characterization of VOx/TiO2 catalytic coatings on stainless steel plates for structured catalytic reactors [Текст] / T. Giornelli, A. Lofberg, E. Bordes-Richard // Applied Catalysis A: General. – 2006. – №305. – С.197–203.
- Giornelli T. Catalytic wall reactor Catalytic coatings of stainless steel by VOx/TiO2 and Co/SiO2 catalysts [Текст] / T. Giornelli, A. Lofberg, L. Guillou et al. // Catalysis Today. – 2007. – №128. – С. 201-207.
- Vaneman, G. L. Comparison of metal foil and ceramic monolith automotive catalytic converters [Текст] / G. L. Vaneman // Catalysis and automotive pollution control II. – 1991. – vol. 71 – C. 537 – 555.
- McCarty, J. G. Stability of supported metal and supported metal oxide combustion catalysts / J. G. McCarty, M. Gusman, D. M. Lowe [та ін.] // Catalysis Today. – 1999. – № 47 – C. 5 – 17.
- Попова, Н. М. Катализаторы очистки газовых выбросов промышленных производств [Текст] / Н. М. Попова - М.: Химия, 1991. - 176 с.
- Гончаров, В. В. Синтез Al2O3 на поверхности блочных носителей для катализаторов из нержавеющей стали [Текст] / В. В. Гончаров, Г. И. Соловьев // Вісник Східноукраїнського національного університету. – 2011. – № 10 (164). – С. 122-126.
- Авторское свидетельство СССР № 784073 кл. BO1J. Способ приготовления цельнометаллического катализатора [Текст] / Г. И. Соловьев, В. К. Скарченко, К. Е. Мохорин. – опубл. 31.05.80.
- Соловьев, Г. И. Изучение кинетики гетерогенно-каталитического окисления метана на платино-палладиевом катализаторе [Текст] / Г. И. Соловьев, В. В. Гончаров, А. А. Климаш // Экотехнологии и ресурсосбережение. – 2008. – №3. – С. 41-44.
- Modeling and Simulation of Heterogeneous Oxidation of Methane on a Platinum Foil [Текст] / Deutschmann O., Behrendt F., and Warnatz J. // Catalysis Today. – 1994. – №21 – С. 461-470.
- Two-dimensional modelling for catalytically stabilized combustion of a lean methane-air mixture with elementary homogeneous and heterogeneous chemical reactions / Dogwiler U., Benz P., and Mantzaras J. // Combustion and flame. – 1999. – №116 – C. 243–258.
- Giornelli T., Lofberg A., Bordes-Richard E. Preparation and characterization of VOx/TiO2 catalytic coatings on stainless steel plates for structured catalytic reactors. Applied Catalysis A: General, 2006, №305, Pp. 197–203.
- Giornelli T., Lofberg A., Guillou L. et al. Catalytic wall reactor Catalytic coatings of stainless steel by VOx/TiO2 and Co/SiO2 catalysts. Catalysis Today, 2007, №128, Pp. 201-207.
- Vaneman G. L. Comparison of metal foil and ceramic monolith automotive catalytic converters. Catalysis and automotive pollution control II, 1991, vol. 71, Pp. 537 – 555.
- McCarty J. G., Gusman M., Lowe D. M. et al. Stability of supported metal and supported metal oxide combustion catalysts. Catalysis Today, 1999, № 47, Pp. 5 – 17.
- Popova N.M. Catalysts for purification of gas emissions from industrial plants [Katalizatory ochistki gazovykh vybrosov promyshlennykh proizvodstv]. М.: Khimiya, 1991, 176 p.
- Goncharov V.V., Soloviev G.I. Synthesis of Al2O3 on the surface of a catalyst support block of stainless steel [Sintez Al2O3 na poverkhnosti blochnykh nositeley dlya katalizatorov iz nerzhaveiushchei stali. Vistnyk Skhidnoukrainskoho natsionalnoho universytetu [Bulletin of the Eastern National University]. 2011. № 10 (164). Pp. 122-126.
- Soloviev G.I., Skarchenko D.R., Mokhorin K.E. Method of preparation of the all-metal catalyst [Sposob prihotovleniia tselnometallicheskoho katalizatorа]. Avtorskoe svidetelstvo SSSR № 784073 кл. BO1J. opubl. 31.05.80.
- Soloviev G.I., Goncharov V.V., Klimash A.A. The study of kinetics of heterogeneous-catalytic oxidation of methane on a platinum-palladium catalyst [Izuchenie kinetiki heterohenno-kataliticheskoho okisleniia metana na platino-palladievom katalizatore] Ekotekhnologii i resursosberezhenie [Environmental technology and resource conservation], 2008, №3, Pp. 41-44.
- Deutschmann O., Behrendt F., and Warnatz J. Modeling and Simulation of Heterogeneous Oxidation of Methane on a Platinum Foil. Catalysis Today, 1994, №21, Pp. 461-470.
- Dogwiler U., Benz P., and Mantzaras J. Two-dimensional modelling for catalytically stabilized combustion of a lean methane-air mixture with elementary homogeneous and heterogeneous chemical reactions. Combustion and flame, 1999, №116, Pp. 243–258.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2014 Андрій Олександрович Климаш, Геннадій Іванович Соловйов, Олег Федосійович Часник
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.
A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.