Influence of the duration of aging the system Ti/Al2O3 in a hydrogen atmosphere on hydrogen sorption, adhesion, tribology, and electrical conductivity of the film
DOI:
https://doi.org/10.15587/1729-4061.2018.144501Keywords:
titanium of grade VT 1-0, method of magnetron sputtering, aluminum oxide, hydrogen atmosphere, adhesion, tribology, electrical conductivity of film surfaceAbstract
This paper reports results on the interaction between an aluminum oxide film, deposited on technically pure titanium of grade VT1-0 by the magnetron reactive sputtering method, and a hydrogen-containing atmosphere. Such a study is important in order to find protective coatings that would prevent the penetration of hydrogen inside a product. A given system aged in a hydrogen atmosphere in the interval of 1‒4 hours at a pressure of 2∙105 Pa (2 bar) and a temperature of 400 °C. We have acquired data on the distribution of hydrogen along a film thickness and its content in a thin-film system. It is shown that hydrogen diffuses into the film and builds up in it up to three hours, and only then it begins to penetrate the substrate. We have managed to increase aging duration in a hydrogen-containing environment and increase the temperature of heating up to the stage of film destruction. In the case of the starting film and after aging from 1 to 3 hours the adhesion force between a film and a substrate increases, apparently due to the formation of hydrogen bonds film-substrate. The adsorption of hydrogen atoms at the surface of the Al2О3 film is accompanied by an increase in its conductivity by not larger than 4 % with the increased time of aging. Such a change in the conductivity of the Al2О3 film can be explained based on the formation of a zone structure. Thin oxide films may possess continuous one-side conductivity, but in the case the film is thick (0.5 µm and above), it is not possible to argue about the one-side conductivity. The data acquired on the influence of aging duration in a hydrogen atmosphere indicate an increase in adhesive strength by almost 6 times within 3 hours and by 2.5 times in 4 hours. The determined coefficient of film friction increases by not larger than 2.5 times. By measuring the electrical conductivity of the film surface, it was found that it increases with an increase in the time of aging in a hydrogen atmosphere. This pattern is obviously linked to the creation of transitions of the p-n-type in the film of aluminum oxide at the expense of hydrogen ionsReferences
- Coenen, J. W., Berger, M., Demkowicz, M. J., Matveev, D., Manhard, A., Neu, R. et. al. (2017). Plasma-wall interaction of advanced materials. Nuclear Materials and Energy, 12, 307–312. doi: https://doi.org/10.1016/j.nme.2016.10.008
- Forcey, K. S., Ross, D. K., Wu, C. H. (1991). The formation of hydrogen permeation barriers on steels by aluminising. Journal of Nuclear Materials, 182, 36–51. doi: https://doi.org/10.1016/0022-3115(91)90413-2
- Zeng, W., Luan, B.-F., Liu, N. (2018). Hydride Phases and Hydride Orientation in Zirconium Alloys. Journal of Materials Engineering, 46 (6), 11–18. doi: https://doi.org/10.11868/j.issn.1001-4381.2016.001027
- Avram, P., Imbrea, M. S., Istrate, B., Strugaru, S. I., Benchea, M., Munteanu, C. (2014). Properties of Al2O3 and NiAlSi coatings obtained by atmospheric plasma spraying on 34CrNiMo6 substrate. Indian Journal of Engineering and Materials Sciences, 21, 315–321.
- Zhang, W., Huang, Y., Dai, W., Jin, X., Yin, C. (2016). A Fracture Analysis of Ti-10Mo-8V-1Fe-3.5Al Alloy Screws during Assembly. Materials, 9 (10), 852. doi: https://doi.org/10.3390/ma9100852
- Rhode, M., Steger, J., Boellinghaus, T., Kannengiesser, T. (2016). Hydrogen degradation effects on mechanical properties in T24 weld microstructures. Welding in the World, 60 (2), 201–216. doi: https://doi.org/10.1007/s40194-015-0285-5
- Teter, D. F., Robertson, I. M., Birnbaum, H. K. (2001). The effects of hydrogen on the deformation and fracture of β-titanium. Acta Materialia, 49 (20), 4313–4323. doi: https://doi.org/10.1016/s1359-6454(01)00301-9
- Pańcikiewicz, K. (2018). Structure and Properties of Welded Joints of 7CrMoVTiB10-10 (T24) Steel. Advances in Materials Science, 18 (1), 37–47. doi: https://doi.org/10.1515/adms-2017-0026
- Yamabe, J., Itoga, H., Awane, T., Matsuo, T., Matsunaga, H., Matsuoka, S. (2015). Pressure Cycle Testing of Cr–Mo Steel Pressure Vessels Subjected to Gaseous Hydrogen. Journal of Pressure Vessel Technology, 138 (1), 011401. doi: https://doi.org/10.1115/1.4030086
- Skołek, E., Marciniak, S., Skoczylas, P., Kamiński, J., Świątnicki, W. A. (2015). Nanocrystalline Steels’ Resistance to Hydrogen Embrittlement. Archives of Metallurgy and Materials, 60 (1), 491–496. doi: https://doi.org/10.1515/amm-2015-0079
- Nikitenkov, N. N., Vilkhivskaya, O. V., Nikitenkov, A. N., Tyurin, Y. I., Sypchenko, V. S., Shulepov, I. A. (2015). Interaction of Al2O3 thin films deposited on nanocrystalline titanium with hydrogen. Thin Solid Films, 591, 169–173. doi: https://doi.org/10.1016/j.tsf.2015.04.011
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2018 Vladimir Sypchenko, Evgeniya Kiselyova, Thorstein Sigfusson, Elena Lisichko, Ludmila Semkina, Natalya Efremova, Vera Rudkovskaya
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.
A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.