Improvement of the current control loop of the single-phase multifunctional grid-tied inverter of photovoltaic system

Authors

DOI:

https://doi.org/10.15587/1729-4061.2019.185391

Keywords:

relay current controller, unipolar and bipolar modulation, power losses, THD, simulation

Abstract

Improvement of the current control loop of the multifunctional grid-tied inverter of the local object electrical power system is considered. The purpose is ensuring compliance with the quality standards of the grid current in the whole range of its values when connecting the load to the AC distribution grid and the converter unit of the photovoltaic system. The use of relay current controller with combining of unipolar and bipolar modulation in combination with a modified algorithm of switching the inverter switches is proposed. It is shown that at a non-linear load, the jump-like change of the derivative of the inverter reference current leads to a sharp change in the switching frequency of the switches. This leads to the appearance of “splashes” in the grid current, which worsens its harmonic composition at small current values.

In the nonlinear reactor with an increase in the inverter current, the “splash” is also caused by changes in the switching frequency of the switches. This takes place in the areas of current growth (fall) due to a change in the reactor inductance. The dependence of the given deviation for the relay controller is established. In the case of a linear reactor, this provides a practically constant switching frequency for the inverter switches. It is proposed to take into account the derivative of the inverter current in the deviation reference of the relay controller. This eliminates an abrupt change in switches switching frequency. The necessity of taking into account the non-sinusoidal grid voltage during the determination of the voltage value at the inverter input is shown. It is proposed to reduce the capacitance of the filter capacitor at the point of common coupling and use of capacitor current coupling. This will improve the quality of the grid current at the non-sinusoidal voltage of the grid. The structure of the current control loop with a relay current controller with the combined modulation and regulation of the reference value of the controller deviation is proposed. Regulation is carried out in accordance with the reference value of the amplitude and the derivative of the inverter current. A mathematical model of the system “grid – grid inverter – load” with a block of determination of power losses in the switches and a nonlinear reactor is developed

Author Biographies

Alexandr Shavelkin, Kyiv National University of Technologies and Design Nemyrovycha-Danchenka str., 2 Kyiv, Ukraine, 01011

Doctor of Technical Sciences, Professor

Department of Energy Management and Applied Electronic Engineering

Jasim Mohmed Jasim Jasim, Al-Furat Al-Awsat Technical University – Al-Musssaib Technical college Al-Najaf Baghdad main road, 15, Al-Kufa, Iraq, 54001

PhD, Associate Professor

Department of Electrical Power Engineering Techniques

Iryna Shvedchykova, Kyiv National University of Technologies and Design Nemyrovycha-Danchenka str., 2 Kyiv, Ukraine, 01011

Doctor of Technical Sciences, Professor

Department of Energy Management and Applied Electronic Engineering

References

  1. Ko, S.-H., Lee, S.-R., Dehbonei, H., Nayar, C. V. (2006). A Grid-Connected Photovoltaic System with Direct Coupled Power Quality Control. IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics. doi: https://doi.org/10.1109/iecon.2006.347757
  2. Zeng, Z., Yang, H., Zhao, R., Cheng, C. (2013). Topologies and control strategies of multi-functional grid-connected inverters for power quality enhancement: A comprehensive review. Renewable and Sustainable Energy Reviews, 24, 223–270. doi: https://doi.org/10.1016/j.rser.2013.03.033
  3. Shavelkin, A. A. (2018). Structures of single-phase convertors units for combined electrical supply systems with photoelectric solar panels. Tekhnichna Elektrodynamika, 2, 39–46. doi: https://doi.org/10.15407/techned2018.02.039
  4. Shavelkin, A., Shvedchykova, I. (2018). Multifunctional converter for single-phase combined power supply systems for local objects with a photovoltaic solar battery. Tekhnichna Elektrodynamika, 5, 92–95. doi: https://doi.org/10.15407/techned2018.05.092
  5. Vigneysh, T., Kumarappan, N. (2017). Grid interconnection of renewable energy sources using multifunctional grid-interactive converters: A fuzzy logic based approach. Electric Power Systems Research, 151, 359–368. doi: https://doi.org/10.1016/j.epsr.2017.06.010
  6. Brochures. ABB solar inverters. Available at: https://new.abb.com/power-converters-inverters/solar
  7. -1992 - IEEE Recommended Practices and Requirements for Harmonic Control in Electrical Power Systems. doi: https://doi.org/10.1109/ieeestd.1993.114370
  8. -2018 - IEEE Standard for Interconnection and Interoperability of Distributed Energy Resources with Associated Electric Power Systems Interfaces. doi: https://doi.org/10.1109/ieeestd.2018.8332112
  9. Da Silva, S. A. O., Sampaio, L. P., Campanhol, L. B. G. (2014). Single-phase grid-tied photovoltaic system with boost converter and active filtering. 2014 IEEE 23rd International Symposium on Industrial Electronics (ISIE). doi: https://doi.org/10.1109/isie.2014.6865013
  10. Martins, D. C., de Souza, K. C. A. (2008). A Single-Phase Grid-Connected PV System With Active Power Filter. International Journal of Circuits, Systems and Signal Processing, 2 (1), 50–55.
  11. Vaquero, J., Vázquez, N., Soriano, I., Vázquez, J. (2018). Grid-Connected Photovoltaic System with Active Power Filtering Functionality. International Journal of Photoenergy, 2018, 1–9. doi: https://doi.org/10.1155/2018/2140797
  12. Mendez, I., Vazquez, N., Vaquero, J., Vazquez, J., Hernandez, C., Lopez, H. (2015). Multifunctional grid-connected photovoltaic-system controlled by sliding mode. IECON 2015 - 41st Annual Conference of the IEEE Industrial Electronics Society. doi: https://doi.org/10.1109/iecon.2015.7392286
  13. Shavelkin, A. A. (2019). Improvement of the structure for the current control loop with the use of PWM for the grid inverter of the combined power supply system. Tekhnichna Elektrodynamika, 3, 37–45. doi: https://doi.org/10.15407/techned2019.03.037
  14. Ma, T.-T. (2012). Power Quality Enhancement in Micro-grids Using Multifunctional DG Inverters. Proceedings of the International MultiConference of Engineers and Computer Scientists. Vol. II, IMECS 2012. Hong Kong, 996–1001.
  15. Mao, H., Yang, X., Chen, Z., Wang, Z. (2012). A Hysteresis Current Controller for Single-Phase Three-Level Voltage Source Inverters. IEEE Transactions on Power Electronics, 27 (7), 3330–3339. doi: https://doi.org/10.1109/tpel.2011.2181419
  16. Shavolkin, O., Shvedchykova, I. (2018). Forming of Current of the Single-Phase Grid Inverter of Local Combined Power Supply System with a Photovoltaic Solar Battery. 2018 IEEE 3rd International Conference on Intelligent Energy and Power Systems (IEPS). doi: https://doi.org/10.1109/ieps.2018.8559540
  17. Wu, T.-F., Nien, H.-S., Shen, C.-L., Chen, T.-M. (2005). A Single-Phase Inverter System for PV Power Injection and Active Power Filtering With Nonlinear Inductor Consideration. IEEE Transactions on Industry Applications, 41 (4), 1075–1083. doi: https://doi.org/10.1109/tia.2005.851035
  18. Machado, S. M., Da Silva, N. (2016). Stability and Harmonic Rejection Analysis of Single-Phase Grid-Connected Inverter Intended for Renewable Energy Systems Considering Distorted Grid Conditions. 2016 CIGRE C4 International Colloquium on EMC, Lightning and Power Quality Considerations for Renewable Energy Systems. Available at: https://www.researchgate.net/publication/299524329
  19. IEEE Std EN 50160:2010. Voltage characteristics of electricity supplied by public electricity networks.
  20. IGBT Modules. SEMIKRON. Available at: https://www.semikron.com/products/product-classes/igbt-modules.html
  21. Shavolkin O. O., Stanovskyiy E. Yu., Pidhainyi M. O. (2019). Modeling of the combined electricpower system of a local object with multifunctionalconverter unit of photovoltaic battery. Visnyk Kyivskoho natsionalnoho universytetu tekhnolohii ta dyzainu, 4 (136), 20–33. doi: https://doi.org/10.30857/1813-6796.2019.4.2

Downloads

Published

2019-12-02

How to Cite

Shavelkin, A., Jasim, J. M. J., & Shvedchykova, I. (2019). Improvement of the current control loop of the single-phase multifunctional grid-tied inverter of photovoltaic system. Eastern-European Journal of Enterprise Technologies, 6(5 (102), 14–22. https://doi.org/10.15587/1729-4061.2019.185391

Issue

Section

Applied physics