Studying acoustic emission by fitting the destruction models of a composite according to the or criterion and Mises criterion

Authors

DOI:

https://doi.org/10.15587/1729-4061.2020.204820

Keywords:

acoustic emission, composite material, signal parameters, destruction criteria, equivalent stresses

Abstract

This paper reports the established patterns of change in the acoustic emission signals by approximating the models of the destruction of a composite material in the form of a bundle of fibers according to the OR criterion and Mises criterion. It has been shown that increasing the coefficient that characterizes the ratio of the size of the elements of the composite material leads to that the pattern of change in the equivalent stresses according to the OR criterion is approaching the pattern of change by Mises criterion. At a certain value of the coefficient, according to the OR criterion, the equivalent stresses are aligned with a minimal deviation from each other. However, this alignment is limited to a specific change period.

We have established patterns of change in the number of elements, which remain, as well as the signals of acoustic emission according to the OR criterion with the regularity of their change approaching that based on the Mises criterion. It has been shown that at the best approximation of the equivalent stresses according to the criteria there is a good agreement of the patterns of change in the number of a composite's elements, remaining in time, and the parameters for the formed signals of acoustic emission with their minimal deviation. It has been determined that the deviations in the parameters of acoustic emission signals are due to the difference in the rate of change in the equivalent stresses in proportion to approaching the time when a composite material starts breaking according to the OR criterion and Mises criterion.

It has been determined that with the increasing deformation rate of a composite material, the patterns of change in the equivalent stresses approaching those based on the OR criterion and Mises criterion, the number of the remaining elements in the composite over time, and the parameters of acoustic emission signals are maintained. However, these patterns are observed at smaller intervals of time. The results obtained could be used in the study of the destructive processes of composite materials, taking into consideration the influence of various factors.

Author Biographies

Sergii Filonenko, National Aviation University Liubomyra Huzara ave., 1, Kyiv, Ukraine, 03058

Doctor of Technical Sciences, Professor

Department of Computerized Electrical Systems and Technologies

Anzhelika Stakhova, National Aviation University Liubomyra Huzara ave., 1, Kyiv, Ukraine, 03058

PhD

Department of Computerized Electrical Systems and Technologies

References

  1. Turcotte, D. L., Newman, W. I., Shcherbakov, R. (2003). Micro and macroscopic models of rock fracture. Geophysical Journal International, 152 (3), 718–728. doi: https://doi.org/10.1046/j.1365-246x.2003.01884.x
  2. Kun, F., Carmona, H. A., Andrade, J. S., Herrmann, H. J. (2008). Universality behind Basquin’s Law of Fatigue. Physical Review Letters, 100 (9). doi: https://doi.org/10.1103/physrevlett.100.094301
  3. Danku, Z., Kun, F. (2014). Record breaking bursts in a fiber bundle model of creep rupture. Frontiers in Physics, 2. doi: https://doi.org/10.3389/fphy.2014.00008
  4. Kovács, K., Hidalgo, R. C., Pagonabarraga, I., Kun, F. (2013). Brittle-to-ductile transition in a fiber bundle with strong heterogeneity. Physical Review E, 87 (4). doi: https://doi.org/10.1103/physreve.87.042816
  5. Bosia, F., Pugno, N., Lacidogna, G., Carpinteri, A. (2008). Mesoscopic modeling of Acoustic Emission through an energetic approach. International Journal of Solids and Structures, 45 (22-23), 5856–5866. doi: https://doi.org/10.1016/j.ijsolstr.2008.06.019
  6. Pugno, N., Bosia, F., Carpinteri, A. (2009). Size effects on the strength of nanotube bundles. Measurement Science and Technology, 20 (8), 084028. doi: https://doi.org/10.1088/0957-0233/20/8/084028
  7. Oskouei, A. R., Ahmadi, M. (2009). Fracture Strength Distribution in E-Glass Fiber Using Acoustic Emission. Journal of Composite Materials, 44 (6), 693–705. doi: https://doi.org/10.1177/0021998309347963
  8. Hader, A., Boughaleb, Y., Achik, I., Sbiaai, K. (2013). Failure kinetic and scaling behavior of the composite materials: Fiber Bundle Model with the local load-sharing rule (LLS). Optical Materials, 36 (1), 3–7. doi: https://doi.org/10.1016/j.optmat.2013.07.035
  9. Lennartz-Sassinek, S., Danku, Z., Kun, F., Main, I. G., Zaiser, M. (2013). Damage growth in fibre bundle models with localized load sharing and environmentally-assisted ageing. Journal of Physics: Conference Series, 410, 012064. doi: https://doi.org/10.1088/1742-6596/410/1/012064
  10. Capelli, A., Reiweger, I., Lehmann, P., Schweizer, J. (2018). Fiber-bundle model with time-dependent healing mechanisms to simulate progressive failure of snow. Physical Review E, 98 (2). doi: https://doi.org/10.1103/physreve.98.023002
  11. Capelli, A., Reiweger, I., Schweizer, J. (2018). Acoustic emission signatures prior to snow failure. Journal of Glaciology, 64 (246), 543–554. doi: https://doi.org/10.1017/jog.2018.43
  12. Pradhan, S., Kjellstadli, J. T., Hansen, A. (2019). Variation of Elastic Energy Shows Reliable Signal of Upcoming Catastrophic Failure. Frontiers in Physics, 7. doi: https://doi.org/10.3389/fphy.2019.00106
  13. Yamada, Y., Yamazaki, Y. (2019). Avalanche Distribution of Fiber Bundle Model with Random Displacement. Journal of the Physical Society of Japan, 88 (2), 023002. doi: https://doi.org/10.7566/jpsj.88.023002
  14. Abaimov, S. G. (2017). Non-equilibrium Annealed Damage Phenomena: A Path Integral Approach. Frontiers in Physics, 5. doi: https://doi.org/10.3389/fphy.2017.00006
  15. Danku, Z., Ódor, G., Kun, F. (2018). Avalanche dynamics in higher-dimensional fiber bundle models. Physical Review E, 98 (4). doi: https://doi.org/10.1103/physreve.98.042126
  16. Monterrubio-Velasco, M., Rodríguez-Pérez, Q., Zúñiga, R., Scholz, D., Aguilar-Meléndez, A., de la Puente, J. (2019). A stochastic rupture earthquake code based on the fiber bundle model (TREMOL v0.1): application to Mexican subduction earthquakes. Geoscientific Model Development, 12 (5), 1809–1831. doi: https://doi.org/10.5194/gmd-12-1809-2019
  17. Raischel, F., Kun, F., Herrmann, H. J. (2005). Simple beam model for the shear failure of interfaces. Physical Review E, 72 (4). doi: https://doi.org/10.1103/physreve.72.046126
  18. Raischel, F., Kun, F., Herrmann, H. J. (2006). Local load sharing fiber bundles with a lower cutoff of strength disorder. Physical Review E, 74 (3). doi: https://doi.org/10.1103/physreve.74.035104
  19. Michlmayr, G., Cohen, D., Or, D. (2013). Shear-induced force fluctuations and acoustic emissions in granular material. Journal of Geophysical Research: Solid Earth, 118 (12), 6086–6098. doi: https://doi.org/10.1002/2012jb009987
  20. Filonenko, S., Kalita, V., Kosmach, A. (2012). Destruction of composite material by shear load and formation of acoustic radiation. Aviation, 16 (1), 1–9. doi: https://doi.org/10.3846/16487788.2012.679831

Downloads

Published

2020-06-30

How to Cite

Filonenko, S., & Stakhova, A. (2020). Studying acoustic emission by fitting the destruction models of a composite according to the or criterion and Mises criterion. Eastern-European Journal of Enterprise Technologies, 3(9 (105), 39–45. https://doi.org/10.15587/1729-4061.2020.204820

Issue

Vol. 3 No. 9 (105) (2020): Information and controlling system

Section

Information and controlling system

License

Copyright (c) 2020 Sergii Filonenko, Anzhelika Stakhova

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.