Development of methods of gas chromatographic analysis of technological media of the main circulation pumps of a nuclear power plant

Authors

DOI:

https://doi.org/10.15587/1729-4061.2020.217234

Keywords:

gas chromatography, turbine oil, cooling water, diagnostic component, nuclear power plant

Abstract

During the operation of power plant equipment, technological media are used – water, turbine oils. Diagnostics of equipment by gas chromatographic determination of diagnostic components (gases Н2, СН4, С2Н6, С2Н4, С2Н2, СО, СО2, О2, N2), water, "Ionol" in these media is urgent. For this, 5 chromatographs are used. An increase in the reliability of the main circulation pumps of a nuclear power plant can be due to an increase in the reliability of its oil system. The influence of ultrasonic vibrations on the generation of gases in the systems "oil – diagnostic gas", "oil – water – diagnostic gas" with the use of turbine oil Тп-22s is studied. Gas concentrations increase with an increase in the duration of exposure for 1600 s at a frequency of 35–125 kHz and a power of 20 W. The dependences of the concentrations Ci of dissolved gases on the irradiation time τ of technological media is expressed by the equation Сi=А∙τ+В Coefficients A, B and correlation coefficients R2 have specific values for each dissolved gas. So, 0.95≤R2≤0.995, which indicates the adequacy of the obtained equations to the experimental data. This makes it possible to determine turbine oil in water after irradiation and subsequent gas chromatographic determination of the generated dissolved gases. The technical requirements for a 5-channel gas chromatograph were established and its structural diagram was developed. This makes it possible to reduce the number of measurement operations and chromatographs. The thresholds for determining the diagnostic components in the corresponding technological environments have been determined: 2 ррm (Н2); 1 ррm (СН4, С2Н6, С2Н4); 0,5 ррm (С2Н2); 5 ррm (СО, СО2); 1,5 ppm (О2, N2); 0.05 wt. % ("Ionol"); 2 g/t (water in turbine oil) 0.02 mg/dm3 (turbine oil in water).

The basic technological scheme of the oil system for the main circulation pumps of the NPP has been developed. It is proposed to continuously: degassing the turbine oil flow; sorption purification of cooling water, analysis of turbine oil and cooling water by gas chromatography methods. This will reduce the degradation of turbine oil and increase the reliability of the oil system of the NPP main circulation pumps

Author Biographies

Sergey Zaitsev, Odessa National Polytechnic University Shevchenka ave., 1, Odessa, Ukraine, 65044

PhD, Associate Professor

Department of Water and Fuel Technology

Victor Kуshnevsky, Odessa National Polytechnic University Shevchenka ave., 1, Odessa, Ukraine, 65044

Doctor of Technical Sciences, Professor

Department of Water and Fuel Technology

Vadim Chichenin, Odessa National Polytechnic University Shevchenka ave., 1, Odessa, Ukraine, 65044

PhD, Associate Professor

Department of Water and Fuel Technology

Anatolii Tykhomyrov, Odessa National Polytechnic University Shevchenka ave., 1, Odessa, Ukraine, 65044

Postgraduate Student

Department of Water and Fuel Technology

References

  1. HKD 34.20.507-2003. Tekhnichna ekspluatatsiya elektrychnykh stantsiy i merezh. Pravyla (2003). Ministerstvo palyva ta enerhetyky Ukrainy. Kyiv: OEP «HRIFRE», 598.
  2. SOU-N EE 20.302:2007. Normy vyprobuvannia elektroobladnannia. Normatyvnyi dokument Minpalyvenerho Ukrainy. Normy (2007). Kyiv: OEP «HRIFRE», 262.
  3. SOU-N EE 46.302:2006. Pidhotovka ta provedennia khromatohrafichnoho analizu vilnykh haziv, vidibranykh iz hazovoho rele, i haziv, rozchynenykh u izoliatsiynomu masli maslonapovnenoho elektroobladnannia. Metodychni vkazivky (2007). Kyiv: OEP «HRIFRE», 70.
  4. IEC 60567:1992-07. Guide for the sampling of gases and of oil from oil-filled electrical equipment and for the analysis of free and dissolved gases (2005). Geneva, 80.
  5. Zaytsev, S. V., Kishnevskiy, V. A., Oborskiy, G. A., Prokopovich, I. V.; Kishnevskiy, V. A. (Ed.) (2019). Sovremennye metody kontrolya energeticheskih masel i produktov ih degradatsii dlya obespecheniya nadezhnosti ekspluatatsii maslonapolnennogo elektrooborudovaniya elektricheskih stantsiy i setey. Odessa: Ekologiya, 304.
  6. ІЕС 60666 Ed. 2.0 b:2010. Detection and determination of specified additives in mineral insulating oils (2010).
  7. SOU-N EE 43.101:2009. Pryimannia, zastosuvannia ta ekspluatatsiya transformatornykh masel. Normy otsiniuvannia yakosti (2009). K.: KVITs: Minpalyvenerho Ukrainy, 152.
  8. ASTM D 4768-96. Standard Test Method for Analysis of 2,6-Ditertiary-Butyl Para-Cresol and 2,6-Ditertiary-Butyl Phenol in Insulating Liquids by Gas Chromatography (1996). ASTM International. doi: http://doi.org/10.1520/D4768-96
  9. RD 34.43.107-95. Procedural Guidelines for the Determination of Content of Water and Air in Transformer Oil (1995). Moscow: «RAO «EES Rossii»».
  10. ISO 9377-2:2000. Water quality – Determination of hydrocarbon oil index – Part 2: Method using solvent extraction and gas chromatography.
  11. SOU NAEK 085:2015. Ekspluatatsiia tekhnolohichnoho kompleksu. Turbinni olyvy dlia enerhetychnoho obladnannia AES. Pravyla ekspluatatsiyi (2015). Kyiv: NAEK «Enerhoatom»: Standart derzhavnoho pidpryiemstva «Natsionalnoi atomnoi enerhoheneruiuchoi kompaniyi «Enerhoatom», 53.
  12. Halikov, R. A., Os'kin, Yu. V., Haziahmetov, M. F., Fashutdinov, A. A. (2015). O defektah teploobmennogo oborudovaniya neftepererabatyvayushchih i neftehimicheskih predpriyatiy. Ekspertiza promyshlennoy bezopasnosti i diagnostika opasnyh proizvodstvennyh obektov, 5, 42–45.
  13. GND 95.1.06.02.002-01. Vodno-himicheskiy rezhim vtorogo kontura atomnyh elektrostantsiy s reaktorami tipa VVER. Tehnicheskie trebovaniya k kachestvu rabochey sredy. Sposoby obespecheniya (2001). Kyiv: Energoatom: GNITS SKAR: Mintopenergo Ukrainy, 23.
  14. SOU-N EE 46.501:2006. Diahnostyka maslonapovnenoho transformatornoho obladnannia za rezultatamy khromatohrafichnoho analizu vilnykh haziv, vidibranykh iz hazovoho rele, i haziv, rozchynenykh u izoliatsiynomu masli. Metodychni vkazivky (2007). Kyiv: OEP «HRIFRE», 92.
  15. Lelekakis, N., Martin, D., Guo, W., Wijaya, J. (2011). Comparison of dissolved gas-in-oil analysis methods using a dissolved gas-in-oil standard. IEEE Electrical Insulation Magazine, 27 (5), 29–35. doi: https://doi.org/10.1109/mei.2011.6025366
  16. Tang, X., Wang, W., Zhang, X., Wang, E., Li, X. (2018). On-Line Analysis of Oil-Dissolved Gas in Power Transformers Using Fourier Transform Infrared Spectrometry. Energies, 11 (11), 3192. doi: https://doi.org/10.3390/en11113192
  17. Arora, R. K. (2013). Different DGA Techniques for Monitoring of Transformers. International Journal of Electronics and Electrical Engineering, 1 (4), 299–303. doi: https://doi.org/10.12720/ijeee.1.4.299-303
  18. Illias, H. A., Zhao Liang, W. (2018). Identification of transformer fault based on dissolved gas analysis using hybrid support vector machine-modified evolutionary particle swarm optimisation. PLOS ONE, 13 (1), e0191366. doi: https://doi.org/10.1371/journal.pone.0191366
  19. Ravichandran, N., Jayalakshmi, V. (2019). Investigations on Power Transformer Faults Based on Dissolved Gas Analysis. International Journal of Innovative Technology and Exploring Engineering (IJITEE), 8 (6S), 296–299.
  20. Zaitsev, S., Kishnevsky, V., Savich, S. (2014). Development of methods for the gas chromatogrphic determination of the content of dissolved components in the energy oils. Eastern-European Journal of Enterprise Technologies, 6 (6 (72)), 34–42. doi: https://doi.org/10.15587/1729-4061.2014.29389
  21. Bryzhatiuk, O. A. (2018). Using of inhibitors in circulating cooling systems of responsible NPP consumers. Tezy dopovidei 53-oi konferentsiyi molodykh doslidnykiv ONPU-mahistrantiv «Suchasni informatsiini tekhnolohiyi ta telekomunikatsiyni merezhi». Odessa: ONPU, 53, 144–149.
  22. Cortes, J. E., Suspes, A., Roa, S., González, C., Castro, H. E. (2012). Total petroleum hydrocarbons by gas chromatography in Colombian waters and soils. American Journal of Environmental Sciences, 8 (4), 396–402. doi: https://doi.org/10.3844/ajessp.2012.396.402
  23. Allahbakhshi, M., Azirani, A. A. (2011). Novel Fusion Approaches for the Dissolved Gas Analysis of Insulating Oil. Iranian Journal of Science and Technology Transaction B: Engineering, 35 (E1), 13–24.
  24. Narang, E., Sehgal, S., Singh, D. (2012). Fault Detection Techniques For Transformer Maintenance Using Dissolved Gas Analysis. International Journal of Engineering Research & Technology (IJERT), 1 (6).
  25. 2.840.030-03D. Hromatografy gazovye «Kristall 2000M». Metodika poverki (2017). Yoshkar-Ola.
  26. Zaitsev, S., Kyshnevsky, V., Shulyak, І. (2015). The method of additives in devising a gas chromatographic method to determine ionol and water in energy oils. Eastern-European Journal of Enterprise Technologies, 2 (6 (74)), 21–28. doi: https://doi.org/10.15587/1729-4061.2015.40896

Downloads

Published

2020-12-31

How to Cite

Zaitsev, S., Kуshnevsky V., Chichenin, V., & Tykhomyrov, A. (2020). Development of methods of gas chromatographic analysis of technological media of the main circulation pumps of a nuclear power plant. Eastern-European Journal of Enterprise Technologies, 6(6 (108), 59–70. https://doi.org/10.15587/1729-4061.2020.217234

Issue

Vol. 6 No. 6 (108) (2020): Technology organic and inorganic substances

Section

Technology organic and inorganic substances

License

Copyright (c) 2020 Sergey Zaitsev, Victor Kуshnevsky, Vadim Chichenin, Anatolii Tykhomyrov

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.