Determining the stressed-strained state of concrete in the zone of exposure to local laser radiation
DOI:
https://doi.org/10.15587/1729-4061.2021.232671Keywords:
heavy concrete, moisture content, laser radiation, protective propertiesAbstract
This paper reports the results of the physical and numerical experiments on determining the stressed-strained state of concrete in protective structures in the region of the effect of local point laser radiation. The software package LIRA10.8 (release 3.4) was used to build a computer model in the statement of a stationary thermal conductivity problem. To this end, the findings from the experimental studies were applied – the resulting temperature distribution and changes in the structure of concrete on the surface and deep into concrete cubes for more than 120 samples of concrete with three levels of moisture content: dried, natural humidity, and water-saturated. This paper gives the parameters of the simulation, the results of a numerical experiment, their analysis, and comparison with the results of a physical experiment.
The temperature fields when establishing the dynamic temperature equilibrium, the level of stresses in concrete, derived from the physical experiments, correlate well with the results of the numerical experiment. The maximum temperature determined by the optical method at the surface of concrete was 1,350+50 °С. Deviations at control points do not exceed 12–70 °С in the temperature effect zone and 18–176 °С (1–11 %). At the rated radiation power of 30 W, the second stage of interaction was achieved; at 100 W – the fourth stage for concrete with a moisture content of 0–2.5 %; and, for water-saturated concrete, the fifth stage of interaction with the laser beam. A significant decrease in the thresholds between the stages of interaction between laser radiation and concrete was revealed, especially water-saturated concrete, compared to the thresholds for metals (the thresholds between the third and fifth stages were reduced by 103–104 times). The destruction of the walls of water-saturated pores in concrete occurred under the pressure of water vapor. The tangent stresses, in this case, were 1.7 MPa, and the values for the coefficient Kр, determined by the method of acoustic emission, were in the range of 4‒6. Such results explain the absence of normal microcracks due to the hoop effect.
It was established that in the contact zone between a laser beam and concrete, about 90 % of the radiation energy dissipates, and in the adjacent heating zone ‒ up to 77 %. The optimal speed of beam movement when cleaning the concrete surface from organic, paint, and other types of contamination of 0.5–2 mm/s (surface temperature, 100–300 °С) has been proposed
References
- Baharev, S., Mirkin, L. I., Shesterikov, S. A. et. al. (1988). Struktura i prochnost' materialov pri lazernyh vozdeystviyah. Moscow: Izd-vo Mosk. un-ta, 224.
- Anishchenko, L. M., Lavrenyuk, S. Yu. (1986). Matematicheskie osnovy proektirovaniya vysokotemperaturnyh tekhnologicheskih protsessov. Moscow: Nauka, 77.
- Wignarajan, S. (1999). New horizons for high-power lasers: applications in civil engineering. Proceeding SPIE, 3887-01, 34–44.
- Uglov, A. A., Smurov, I. Yu., Lashin, A. M., Gus'kov, A. G. (1991). Modelirovanie teplofizicheskih protsessov impul'snogo lazernogo vozdeystviya na metally. Moscow: Nauka, 288.
- Rożniakowski, K. (2001). Zastosowanie promieniowania laserowego w badaniach i modyfikacji właściwości materiałow budowlanych. Studia z zakresu inżynierii NR 50. Warsżawa-Łódż, 200.
- Romanowska, A., Jablonski, M. (2001). Kompozyt gipsowy o podwyższonej akumulacji cipła. Studia z zakresu inżynierii NR 50. Warsżawa-Łódż, 102.
- Gawin D., Kośny J., Wilkes, K. (2005). Wpływ zawartości wilgoci na dokładność pomiary współczynnika przewodzenia cipła betonu komórkowego metodą stacjonarną. Polska academia nauk. Studia z zakresu inżynierii NR 50. Warsżawa-Łódż, 88.
- Kamata, H., Mimori, T., Tachiiwa, M., Sugimoto, K. (1996). New Applications of Lasers to Architecture and Civil Engineering. Study on Methods for Decontaminating Concrete Surface by Laser Treatment. The Review of Laser Engineering, 24 (2), 182–190. doi: https://doi.org/10.2184/lsj.24.182
- Hamasaki, M. (1987). Experimental cutting of biological shield concrete using laser. Proc. International Symposium on Laser Processing. Tokio.
- Stashuk, P. M. (2001). Vyvchennia kinetyky protsesiv trishchynoutvorennia metodom akustychnoi emisiyi. Visnyk Derzhavnoho universytetu “Lvivska politekhnika” Teoriya ta praktyka budivnytstva, 178–184.
- Filonenko, S. F. (2000). Analiz kinetiki razvitiya protsessov razrusheniya metodom akusticheskoy emissii. Mezhdunarodnaya nauchnaya konferentsiya “Sinergetika 2000. Samoorganizuyushchiesya protsessy v sistemah i tekhnologiyah”. Komsomol'sk-na-Amure, 94–97.
- Long, N. P., Daido, H., Yamada, T., Nishimura, A., Hasegawa, N., & Kawachi, T. (2017). Experimental characterization of concrete removal by high-power quasicontinuous wave fiber laser irradiation. Journal of Laser Applications, 29 (4), 041501. doi: https://doi.org/10.2351/1.5008326
- Lawrence, J., Li, L. High power diode laser surface glazing of concrete. CORE. Available at: https://core.ac.uk/download/pdf/53233.pdf
- Sakai, Y., Sikombe, I., Watanabe, K., Inoue, H. (2019). Microscopic Change in Hardened Cement Paste due to High-Speed Impact. Journal of Advanced Concrete Technology, 17 (9), 518–525. doi: https://doi.org/10.3151/jact.17.518
- DSTU B V.2.7-214:2009. Building material. Concretes. Methods for strength determination using reference specimens (2010). Kyiv, 43.
- DSTU B V.2.7-170:2008. Building materials. Concretes. Methods of determination of middle density, moisture content, water absorptions porosity and watertightness. Kyiv.
- Karhut, I. I. (2019). Influence of laser radiation on heavy concrete. Resource-saving materials, structures, buildings and structures, 37, 35–47. doi: https://doi.org/10.31713/budres.v0i37.311
- Karkhut, I. I., Bula, S. S., Soroka, Ya. V. (2007). Rozpodil temperatury v obiemi betonu pry diyi teplovoho udaru, yak vydu mistsevoho nahrivu. VII Mizhnarodnyi sympozium «Mekhanika ta fizyka ruinuvannia budivelnykh materialiv i konstruktsiy». Kyiv, 7, 191–197.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2021 Игорь Иванович Кархут
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.
A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.