Development of mechanical coupling and exciter system in synchronous generators

Authors

DOI:

https://doi.org/10.15587/1729-4061.2021.246619

Keywords:

synchronous generator, mechanical coupling, exciter system, rectifier, three-phase generator, diesel generator

Abstract

Power is generated in a variety of ways, including renewable energy, nuclear power, and burning of fossil fuels. The majority of our power is currently generated by burning fossil fuels, mostly natural gas and coal, to spin turbines attached to an electromagnetic generator. The main advantage of AC generation is that the voltage levels can be altered up and down with transformers, allowing electricity to be sent across long distances to the loads that demand it. The excitation system demand for large synchronous generators with a few hundred-megawatt ratings becomes very enormous. The challenge of transmitting such a big amount of power through high-speed sliding contacts becomes daunting. Mechanical coupling with exciter for synchronous generators is essential to mitigate such problems as the corrected output is linked directly to the field winding. This paper aims to develop a simulation of a 3-phase diesel engine-based 2 MVA/400 V synchronous generator with mechanical coupling and an exciter system. The developed simulation of the synchronous machine is set to deliver 25 % of its rating value (500 kW) till the time of 3 sec. Then, additional power of 1 MW is switched at t=3 sec via a 3-phase circuit breaker. The dynamic response of field current and field voltage of the simulation shows reasonable step performance as the steady-state time is less than 3 sec. The control of the excitation system allows the generator to maintain voltage, control reactive power flow, and assist in maintaining power system stability. The simulation was accurate when measuring the voltage and current under these changes. This analysis can help to investigate further integration with renewable energy sources.

Supporting Agency

  • The authors gratefully acknowledge the Department of contracting, Energy Transmission Company, south region-Basra-Iraq for the support.

Author Biography

Raad Lafta Damij, Energy Transmission Company

Head of Department

Department of Contracting

References

  1. Atilgan, B., Azapagic, A. (2015). Life cycle environmental impacts of electricity from fossil fuels in Turkey. Journal of Cleaner Production, 106, 555–564. doi: https://doi.org/10.1016/j.jclepro.2014.07.046
  2. Kefford, B. M., Ballinger, B., Schmeda-Lopez, D. R., Greig, C., Smart, S. (2018). The early retirement challenge for fossil fuel power plants in deep decarbonisation scenarios. Energy Policy, 119, 294–306. doi: https://doi.org/10.1016/j.enpol.2018.04.018
  3. Gorginpour, H. (2018). Optimal design of brushless AC exciter for large synchronous generators considering grid codes requirements. IET Generation, Transmission & Distribution, 12 (17), 3954–3962. doi: https://doi.org/10.1049/iet-gtd.2018.5446
  4. Abramov, E., Vekslender, T., Kirshenboim, O., Peretz, M. M. (2018). Fully Integrated Digital Average Current-Mode Control Voltage Regulator Module IC. IEEE Journal of Emerging and Selected Topics in Power Electronics, 6 (2), 485–499. doi: https://doi.org/10.1109/jestpe.2017.2771949
  5. Liu, W., Qin, G., Zhu, Q., Hu, G. (2018). Synchronous extraction circuit with self-adaptive peak-detection mechanical switches design for piezoelectric energy harvesting. Applied Energy, 230, 1292–1303. doi: https://doi.org/10.1016/j.apenergy.2018.09.051
  6. Generator Excitation Control Systems and Methods. Available at: https://www.generatorsource.com/Generator-Excitation-Methods.aspx
  7. Ygzaw, A., Banteyirga, B., Darsema, M. (2020). Generator Excitation Loss Detection on Various Excitation Systems and Excitation System Failures. Advances of Science and Technology, 382–394. doi: https://doi.org/10.1007/978-3-030-43690-2_26
  8. Hammons, T. J. (1978). Influence of Exciter and LP Turbine Blade Dynamics on the Mechanical Stressing of Large Synchronous-Generator Shafts Following Clearance of System Faults and Out-of-Phase Synchronisation.
  9. Ma, P., Liu, W.-G., Luo, G.-Z., Jiao, N.-F., Yang, N.-F. (2012). Starting control strategy for three-stage aviation brushless synchronous motor. Dianji yu Kongzhi Xuebao/Electric Machines and Control, 16 (11), 29–32.
  10. Ortega, R., Galaz-Larios, M., Bazanella, A. S., Stankovic, A. (2001). Excitation control of synchronous generators via total energy-shaping. Proceedings of the 2001 American Control Conference. (Cat. No.01CH37148). doi: https://doi.org/10.1109/acc.2001.945816
  11. Schulte, S., Hameyer, K. (2007). Reduction of force exciting influences to decrease radiation of acoustic noise in synchronous machines. COMPEL - The International Journal for Computation and Mathematics in Electrical and Electronic Engineering, 26 (4), 1017–1027. doi: https://doi.org/10.1108/03321640710756348
  12. Parwal, A., Fregelius, M., Silva, D. C., Potapenko, T., Hjalmarsson, J., Kelly, J. et. al. (2019). Virtual Synchronous Generator Based Current Synchronous Detection Scheme for a Virtual Inertia Emulation in SmartGrids. Energy and Power Engineering, 11 (03), 99–131. doi: https://doi.org/10.4236/epe.2019.113007
  13. Mseddi, A., Le Ballois, S., Aloui, H., Vido, L. (2019). Robust control of a wind conversion system based on a hybrid excitation synchronous generator: A comparison between H∞ and CRONE controllers. Mathematics and Computers in Simulation, 158, 453–476. doi: https://doi.org/10.1016/j.matcom.2018.11.004
  14. Leng, X., Xu, S. (2021). Research on Intelligent Control of Synchronous Generator Excitation System Based on Computer Technology. Journal of Physics: Conference Series, 1992 (3), 032125. doi: https://doi.org/10.1088/1742-6596/1992/3/032125
  15. Chelladurai, J., Vinod, B., Bogaraj, T., Kanakaraj, J., Sundaram, M. (2015). Scalar Controlled Boost PWM Rectifier for Micro Wind Energy Systems. Research Journal of Applied Sciences, Engineering and Technolog, 10 (1), 35–44. doi: https://doi.org/10.19026/rjaset.10.2551

Downloads

Published

2021-12-24

How to Cite

Damij, R. L. (2021). Development of mechanical coupling and exciter system in synchronous generators . Eastern-European Journal of Enterprise Technologies, 6(8 (114), 34–40. https://doi.org/10.15587/1729-4061.2021.246619

Issue

Section

Energy-saving technologies and equipment