Working out of axiscentrifugal compressor for the power engine of low power

Authors

  • В.Е. Спицын ЦНИОКР «Зоря»-«Машпроект» г. Николаев, Ukraine
  • Е.А. Токарева Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев, Ukraine
  • М.А. Шаровский Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев, Ukraine
  • А.В. Ивченко Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев, Ukraine
  • М.Ю. Шелковский Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев, Ukraine

DOI:

https://doi.org/10.15587/1729-4061.2010.2765

Keywords:

mixed-flow (axial-centrifugal) compressor, aerodynamic characteristics, directing vane, compressor stand.

Abstract

It is created the high-pressure, low flow rate compressor for the power engine of low power. In ten axial and one centrifugal stage the high degree of compression and a sufficient level of efficiency for compressors of such class is received. Ways of the further increase of efficiency of the axial-centrifugal compressor are offered.

Author Biographies

В.Е. Спицын, ЦНИОКР «Зоря»-«Машпроект» г. Николаев

Кандидат технических наук, главный конструктор

Е.А. Токарева, Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев

Ведущий специалист сектора газодинамики

М.А. Шаровский, Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев

Начальник сектора газодинамики

А.В. Ивченко, Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев

Ведущий специалист сектора газодинамики

М.Ю. Шелковский, Отдел компрессоров ЦНИОКР «Зоря»-«Машпроект» г. Николаев

Инженер сектора газодинамики

References

  1. Бойко А.В., Говорущенко Ю.Н., Ершов С.В., Русанов А.В., Северин С.Д. Аэродинамический расчет и оптимальное проектирование проточной части турбомашин. – Харьков, НТУ «ХПИ», 2002.
  2. Зангер. Использование методов оптимизации при проектировании компрессоров с управляемой локальной диффузорностью межлопаточных каналов. Тр. америк. общ. инж.-мех. Сер.: Энергетические машины и установки. – 1983. -№2. с. 14-21.
  3. Исследование компрессорных решеток с управляемой формой средней линии профиля. В.С. Бекнев, С.Е. Василенко, М.Ю.Сорокалетов, Р.З. Тумашев, М.А. Шаровский. Теплоэнергетика. – 1997.- №4. – с.38-42.
  4. Василенко С.Е., Огнев В.В., Тумашев Р.З. Влияние формы средней линии профилей на потери в концевых областях прямых компрессорных решеток. – Изв. вузов. Машиностроение, №2. – 1987.-c. 76-79.
  5. Налимов В.В. Теория эксперимента. М.:Наука, 1971, 207с.

Downloads

Published

2010-04-06

How to Cite

Спицын, В., Токарева, Е., Шаровский, М., Ивченко, А., & Шелковский, М. (2010). Working out of axiscentrifugal compressor for the power engine of low power. Eastern-European Journal of Enterprise Technologies, 3(2(45), 70–73. https://doi.org/10.15587/1729-4061.2010.2765

Issue

Vol. 3 No. 2(45) (2010): Modern technologies in gas-turbine construction. Part I

Section

Modern technologies in the gas-turbine

License

Copyright (c) 2014 В.Е. Спицын, Е.А. Токарева, М.А. Шаровский, А.В. Ивченко, М.Ю. Шелковский

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.