COMPARISON OF DIFFERENT TECHNIQUES FOR THE DETERMINATION OF RESIDUAL STRESSES IN POLYMER COATINGS

Authors

  • Николай Анатольевич Долгов Институт проблем прочности им. Г.С.Писаренко НАН Украины ул. Тимирязевская, 2, г. Киев, Украина, 01014, Ukraine
  • Наталья Николаевна Букетова Херсонская государственная морская академия пр. Ушакова, 20, г. Херсон, Украина, 73000, Ukraine
  • Анатолий Владимирович Бесов Институт проблем материаловедения им. И.Н. Францевича НАН Украины ул. Кржижановского, 3, г. Киев, Украина, 03680, Ukraine

DOI:

https://doi.org/10.15587/1729-4061.2012.4059

Keywords:

residual stress, synthesis, polymer coatings

Abstract

We investigated different approaches to determining residual stress in polymer coatings by the cantilever bending coated specimens was studued.  It was shown in the case of epoxy coatings that the calculation of residual stresses without stress relaxation at bending of the coating can give understated almost twice the residual stresses.

Author Biographies

Николай Анатольевич Долгов, Институт проблем прочности им. Г.С.Писаренко НАН Украины ул. Тимирязевская, 2, г. Киев, Украина, 01014

Кандидат технических наук, старший научный сотрудник

Наталья Николаевна Букетова, Херсонская государственная морская академия пр. Ушакова, 20, г. Херсон, Украина, 73000

Аспирантка

Кафедра технической механики, инженерной и компьютерной графики

Анатолий Владимирович Бесов, Институт проблем материаловедения им. И.Н. Францевича НАН Украины ул. Кржижановского, 3, г. Киев, Украина, 03680

Кандидат технических наук, старший научный сотрудник

References

  1. Санжаровский А.Т. Физико-механические свойства полимерных и лакокрасочных покрытий / А.Т. Санжаровский. – М. : Химия, 1978. – 184 с.
  2. Стухляк П.Д. Епоксикомпозитні матеріали, модифіковані ультрафіолетовим опроміненням / П.Д. Стухляк, А.В. Букетов.
  3. – Тернопіль : Збруч, 2009. – 237 с.
  4. Дослідження епоксикомпозитів, що містять модифіковані олігомерами наповнювачі / А. Букетов, П. Стухляк, В. Левицький, М. Долгов // Вісник ТДТУ. – 2004. – Т. 9, № 2. – С. 52 – 59.
  5. Пластмассы. Методы определения модуля упругости при растяжении, сжатии и изгибе: ГОСТ 9550-81. Введ. 01.07.82. – М. : Изд-во стандартов, 2004. – 8 с.
  6. Corcoran E.M. Determining stresses in organic coatings using plate beam deflection / E.M. Corcoran // Journal of Paint Technology. – 1969. – V. 41, No 538. – P. 635 – 640.
  7. Chow T.S. Strains induced upon drying thin films solvent-cast on flexible substrates / T.S. Chow, C.A. Liu, R.C. Penwell // Journal of Polymer Science : Polymer Physics Edition. – 1976. – V. 14, No 7. – P. 1311 – 1316.
  8. Croll S.G. Internal stress in a solvent-cast thermoplastic coating / S.G. Croll // Journal of Coatings Technology. – 1978. – V.50, No 638. – P. 33 – 38.

Downloads

Published

2012-06-01

How to Cite

Долгов, Н. А., Букетова, Н. Н., & Бесов, А. В. (2012). COMPARISON OF DIFFERENT TECHNIQUES FOR THE DETERMINATION OF RESIDUAL STRESSES IN POLYMER COATINGS. Eastern-European Journal of Enterprise Technologies, 3(7(57), 40–42. https://doi.org/10.15587/1729-4061.2012.4059

Issue

Vol. 3 No. 7(57) (2012): Applied mechanics

Section

Applied mechanics

License

Copyright (c) 2014 Николай Анатольевич Долгов, Наталья Николаевна Букетова, Анатолий Владимирович Бесов

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.