Influence of the mean volumetric temperature of a thermoelement on reliability indicators and the dynamics of a cooler

Authors

DOI:

https://doi.org/10.15587/1729-4061.2019.154991

Keywords:

thermo-element branch, mean volumetric temperature, reliability indicators, dynamics of cooler

Abstract

The paper deals with the influence of the mean volumetric temperature of a thermo-element branch on the basic parameters, reliability indicators and the dynamics of operation of thermo-electric cooler under different temperature changes at the assigned heat load, geometry of branches of thermo-elements for specific current operation modes. It was shown that the mean temperature of the thermo-element, which is a reference point when calculating the energy performance of the thermoelectric cooler, can be used only for calculations in the stationary operation mode. Its use in the dynamic mode leads to significant errors. It was proven that the mean volumetric temperature of a thermo-electric branch can be such a reference point for a dynamic mode. The ratio for assessment of the mean volumetric temperature depending on the relative operating current was determined. The relationships between the mean volumetric temperature of a thermo-element, the time required to enter a stationary mode, the required number of thermo-elements, the differences between the mean volumetric and the mean temperature, and a cooling coefficient, depending on the relative working current, were analyzed. It was shown that at an increase in the mean volumetric temperature at the assigned current operation mode and a temperature difference, exceeding 40K, the magnitude of operating current, the number of thermo-elements, consumption power, failure rate and time constant decrease and cooling factor increases. The time for entering a stationary mode during the transition from the mode of minimum failure rate to the mode of maximum cooling capacity decreases by 5 %, while the failure rate increases by 16 %.

The practical significance of the conducted research is both to improve the quality of design of coolers and to select the necessary modes of thermo-electric system for ensuring thermal modes of electronic equipment depending on the importance of dynamic or reliability criteria of control

Author Biographies

Vladimir Zaykov, State Enterprise «Research Institute «SHTORM» Tereshkovoi str., 27, Odessa, Ukraine, 65076

PhD, Chief of Sector

Vladimir Mescheryakov, Odessa State Environmental University Lvivska str., 15, Odessa, Ukraine, 65016

Doctor of Technical Sciences, Professor, Head of Department

Department of Informatics

Yurii Zhuravlov, National University «Odessa Maritime Academy» Didrikhsona str., 8, Odessa, Ukraine, 65029

PhD, Associate Professor

Department of Technology of Materials and Ship Repair

References

  1. Zaykov, V. P., Kinshova, L. A., Moiseev, V. F. (2009). Prediction of reliability indicators, thermoelectric cooling devices. Book 1. One-stage devices. Odessa: Polytehperiodika, 120.
  2. Apartsev, O. R. (2017). Thermoelectric coolers and thermal processes in terms of SPICE modeling. Electronics and electrical engineering, 2, 1–12. doi: https://doi.org/10.7256/2453-8884.2017.2.21379
  3. Belova, O. V., Chernyshev, A. V. (2004). Mathematical Modeling of Heat Sources in Peltier Thermoelectric Elements. Scientific Instrument Making, 14 (1), 51–57.
  4. Ordin, S. V. (2018). Experimental and Theoretical Expansion of the Phenomenology of Thermoelectricity. Global Journal of Science Frontier Research: A Physics and Space Science, 18 (1), 1–8.
  5. Bochegov, V. I., Grabov, V. M. (2017). On the thermal conductivity of the gradient-inhomogeneous branches of thermoelements at a difference in the operating temperature. Semiconductors, 51 (7), 874–875. doi: https://doi.org/10.1134/s106378261707003x
  6. Poudel, B., Hao, Q., Ma, Y., Lan, Y., Minnich, A., Yu, B. et. al. (2008). High-Thermoelectric Performance of Nanostructured Bismuth Antimony Telluride Bulk Alloys. Science, 320 (5876), 634–638. doi: https://doi.org/10.1126/science.1156446
  7. Zhang, L., Wu, Z., Xu, X., Xu, H., Wu, Y., Li, P., Yang, P. (2010). Approach on thermoelectricity reliability of board-level backplane based on the orthogonal experiment design. International Journal of Materials and Structural Integrity, 4 (2/3/4), 170. doi: https://doi.org/10.1504/ijmsi.2010.035205
  8. Choi, H.-S., Seo, W.-S., Choi, D.-K. (2011). Prediction of reliability on thermoelectric module through accelerated life test and Physics-of-failure. Electronic Materials Letters, 7 (3), 271–275. doi: https://doi.org/10.1007/s13391-011-0917-x
  9. Zaykov, V., Mescheryakov, V., Zhuravlov, Y. (2018). Analysis of relationship between the dynamics of a thermoelectric cooler and its design and modes of operation. Eastern-European Journal of Enterprise Technologies, 1 (8 (91)), 12–24. doi: https://doi.org/10.15587/1729-4061.2018.123891
  10. Egorov, V. I. (2006). Exact methods for solving heat conduction problems. Saint Petersburg: St. Petersburg State University ITMO, 48.

Downloads

Published

2019-01-23

How to Cite

Zaykov, V., Mescheryakov, V., & Zhuravlov, Y. (2019). Influence of the mean volumetric temperature of a thermoelement on reliability indicators and the dynamics of a cooler. Eastern-European Journal of Enterprise Technologies, 1(8 (97), 36–42. https://doi.org/10.15587/1729-4061.2019.154991

Issue

Section

Energy-saving technologies and equipment