Substantiating the criteria for selecting rectifier diodes for low-power rectenna energy harvesting systems

Authors

DOI:

https://doi.org/10.15587/1729-4061.2026.355841

Keywords:

rectenna, RF energy harvesting, Schottky diode, impedance matching, conversion efficiency

Abstract

The process of rectifying electromagnetic field energy in micropower rectennas based on Schottky diodes has been investigated in this study. One of the challenges in designing such rectennas is the lack of a consistent system of quantitative criteria for selecting a rectifier diode capable of providing high conversion efficiency at ultra-low input power levels while accounting for its intrinsic and parasitic parameters. The practical relevance of this task is predetermined by the need to autonomously power Internet of Things sensors in weak electromagnetic fields.

Decomposition of loss mechanisms was performed, which made it possible to distinguish the fundamental limitations caused by the current-voltage characteristic from the frequency-dependent and parasitic diode parameters. The study was carried out using the harmonic balance method in AWR Design Environment.

The calculations showed that, in the microwatt regime, higher conversion efficiency is achieved for diodes with increased saturation current due to the dominant role of the junction threshold properties. For low-barrier structures, an increase in temperature above 50°C is accompanied by a sharp rise in reverse leakage currents, which leads to a decrease in efficiency. As the frequency increases, the junction barrier capacitance and the package parasitics increasingly limit the achievable efficiency, especially at 2.45 and 5.8 GHz.

Comparative modeling of commercial Schottky diodes revealed that, under the micropower regime, preference should be given to low-barrier structures with minimized parasitic reactances, whereas at higher input power levels the advantage may shift to structures with a medium barrier height.

Underlying the practical value of this study is the compilation of recommendations for the justified selection of components when designing battery-free power supply systems for Internet of Things sensors operating in weak electromagnetic fields.

Author Biographies

Vasyl Alieksieiev, Kharkiv National University of Radio Electronics

PhD Student

Department of Computer Radio Engineering and Technical Information Security Systems

Dmytro Hretskykh, Kharkiv National University of Radio Electronics

Doctor of Technical Sciences

Department of Computer Radio Engineering and Technical Information Security Systems

Dmytro Havva, Kharkiv National University of Radio Electronics

PhD

Department of Computer Radio Engineering and Technical Information Security Systems

Mikhail Nesterenko, V. N. Karazin Kharkiv National University

Doctor of Physical and Mathematical Sciences

Department of Physics of Ultra High Frequencies

Olena Ivanova, Kharkiv National University of Radio Electronics

PhD

Department of Computer Radio Engineering and Technical Information Security Systems

References

  1. Tran, L.-G., Cha, H.-K., Park, W.-T. (2017). RF power harvesting: a review on designing methodologies and applications. Micro and Nano Systems Letters, 5 (1). https://doi.org/10.1186/s40486-017-0051-0
  2. Nikoletseas, S., Yang, Y., Georgiadis, A. (Eds.) (2016). Wireless Power Transfer Algorithms, Technologies and Applications in Ad Hoc Communication Networks. Springer International Publishing. https://doi.org/10.1007/978-3-319-46810-5
  3. Shinohara, N. (2013). Wireless Power Transfer via Radiowaves. John Wiley & Sons. https://doi.org/10.1002/9781118863008
  4. Hemour, S., Wu, K. (2014). Radio-Frequency Rectifier for Electromagnetic Energy Harvesting: Development Path and Future Outlook. Proceedings of the IEEE, 102 (11), 1667–1691. https://doi.org/10.1109/jproc.2014.2358691
  5. Costanzo, A., Masotti, D. (2017). Energizing 5G: Near- and Far-Field Wireless Energy and Data Trantransfer as an Enabling Technology for the 5G IoT. IEEE Microwave Magazine, 18 (3), 125–136. https://doi.org/10.1109/mmm.2017.2664001
  6. Valenta, C. R., Durgin, G. D. (2014). Harvesting Wireless Power: Survey of Energy-Harvester Conversion Efficiency in Far-Field, Wireless Power Transfer Systems. IEEE Microwave Magazine, 15 (4), 108–120. https://doi.org/10.1109/mmm.2014.2309499
  7. Zhang, Z., Pang, H., Georgiadis, A., Cecati, C. (2019). Wireless Power Transfer – An Overview. IEEE Transactions on Industrial Electronics, 66 (2), 1044–1058. https://doi.org/10.1109/tie.2018.2835378
  8. Popovic, Z. (2017). Near- and far-field wireless power transfer. 2017 13th International Conference on Advanced Technologies, Systems and Services in Telecommunications (TELSIKS), 3–6. https://doi.org/10.1109/telsks.2017.8246215
  9. Gu, X., Hemour, S., Wu, K. (2022). Far-Field Wireless Power Harvesting: Nonlinear Modeling, Rectenna Design, and Emerging Applications. Proceedings of the IEEE, 110 (1), 56–73. https://doi.org/10.1109/jproc.2021.3127930
  10. Smith, D. R., Gowda, V. R., Yurduseven, O., Larouche, S., Lipworth, G., Urzhumov, Y., Reynolds, M. S. (2017). An analysis of beamed wireless power transfer in the Fresnel zone using a dynamic, metasurface aperture. Journal of Applied Physics, 121 (1). https://doi.org/10.1063/1.4973345
  11. Fowler, C., Silva, S., Thapa, G., Zhou, J. (2022). High efficiency ambient RF energy harvesting by a metamaterial perfect absorber. Optical Materials Express, 12 (3), 1242. https://doi.org/10.1364/ome.449494
  12. Visser, H. J., Vullers, R. J. M. (2013). RF Energy Harvesting and Transport for Wireless Sensor Network Applications: Principles and Requirements. Proceedings of the IEEE, 101 (6), 1410–1423. https://doi.org/10.1109/jproc.2013.2250891
  13. Pinuela, M., Mitcheson, P. D., Lucyszyn, S. (2013). Ambient RF Energy Harvesting in Urban and Semi-Urban Environments. IEEE Transactions on Microwave Theory and Techniques, 61 (7), 2715–2726. https://doi.org/10.1109/tmtt.2013.2262687
  14. Saito, K., Nishiyama, E., Toyoda, I. (2022). A 2.45- and 5.8-GHz Dual-Band Stacked Differential Rectenna With High Conversion Efficiency in Low Power Density Environment. IEEE Open Journal of Antennas and Propagation, 3, 627–636. https://doi.org/10.1109/ojap.2022.3171035
  15. Chandravanshi, S., Sarma, S. S., Akhtar, M. J. (2018). Design of Triple Band Differential Rectenna for RF Energy Harvesting. IEEE Transactions on Antennas and Propagation, 66 (6), 2716–2726. https://doi.org/10.1109/tap.2018.2819699
  16. Contreras, A., Urdaneta, M. (2021). Analysis of Variance of the Diode Parameters in Multiband Rectifiers for RF Energy Harvesting. Radioengineering, 30 (1), 150–156. https://doi.org/10.13164/re.2021.0150
  17. Paz, H. P. D., Silva, V. S. D., Diniz, R., Trevisoli, R., Capovilla, C. E., Casella, I. R. S. (2023). Temperature Analysis of Schottky Diodes Rectifiers for Low-Power RF Energy Harvesting Applications. IEEE Access, 11, 54122–54132. https://doi.org/10.1109/access.2023.3281794
  18. Sze, S. M., Ng, K. K. (2006). Physics of Semiconductor Devices. John Wiley & Sons. https://doi.org/10.1002/0470068329
  19. Maas, S. A. (2003). Nonlinear Microwave and RF Circuits. Boston: Artech House, 608. Available at: https://us.artechhouse.com/Nonlinear-Microwave-and-RF-Circuits-Second-Edition-P1097.aspx
  20. Quarles, T., Newton, A. R., Pederson, D. O., Sangiovanni-Vincentelli, A. (1993). SPICE3 Version 3f3 User’s Manual. Berkeley, 145. Available at: http://www.gianlucafiori.org/appunti/Spice_3f3_Users_Manual.pdf
  21. Gretskih, D. V., Luchaninov, A. I., Vishniakova, J. V., Katrich, V. A., Nesterenko, M. V. (2018). Electrodynamic Model of a Wireless Power Transmission System. 2018 XXIIIrd International Seminar/Workshop on Direct and Inverse Problems of Electromagnetic and Acoustic Wave Theory (DIPED), 80–85. https://doi.org/10.1109/diped.2018.8543290
  22. Luchaninov, A. I., Gretskih, D. V., Gomozov, A. V., Katrich, V. A., Nesterenko, M. V. (2019). Electrodynamic Approach to Designing WPT Systems with Accounting for Non-system Interactions. 2019 IEEE 2nd Ukraine Conference on Electrical and Computer Engineering (UKRCON), 107–111. https://doi.org/10.1109/ukrcon.2019.8879788
  23. Gretskih, D., Luchaninov, A., Katrich, V., Nesterenko, M. (2019). Electrodynamic Approach to Designing Wireless Power Transfer Systems (Internal System Processes). 2019 International Conference on Information and Telecommunication Technologies and Radio Electronics (UkrMiCo), 1–6. https://doi.org/10.1109/ukrmico47782.2019.9165536
  24. Gretskih, D., Luchaninov, A., Katrich, V., Nesterenko, M., Gomozov, A. (2019). Extemal Parameters of Wireless Power Transmission Systems. 2019 XXIVth International Seminar/Workshop on Direct and Inverse Problems of Electromagnetic and Acoustic Wave Theory (DIPED), 117–121. https://doi.org/10.1109/diped.2019.8882592
  25. Alieksieiev, V., Gretskih, D., Luchaninov, A., Lykhograi, V., Shcherbina, A. (2021). Applying the Electrodynamic Approach to Modeling Wireless Power Transmission Systems. 2021 IEEE 26th International Seminar/Workshop on Direct and Inverse Problems of Electromagnetic and Acoustic Wave Theory (DIPED), 111–115. https://doi.org/10.1109/diped53165.2021.9552254
  26. AWR Design Environment Platform (2026). Cadence Design Systems. Available at: https://www.cadence.com/en_US/home.html
  27. Roberg, M., Falkenstein, E., Popovic, Z. (2012). High-efficiency harmonically-terminated rectifier for wireless powering applications. 2012 IEEE/MTT-S International Microwave Symposium Digest, 1–3. https://doi.org/10.1109/mwsym.2012.6259641
  28. Nelder, J. A., Mead, R. (1965). A Simplex Method for Function Minimization. The Computer Journal, 7 (4), 308–313. https://doi.org/10.1093/comjnl/7.4.308
  29. The Zero Bias Schottky Detector Diode: Application Note 969. San Avago Technologies, 6. Available at: https://people.ee.ethz.ch/~mzahner/PPS-EMrad/material/literature/RF-Detectors_Receivers/The%20Zero%20Bias%20Schottky%20Detector%20Diode%20(Avago%20AN%20969).pdf
  30. SMS7630 Series. Surface Mount Mixer and Detector Schottky Diodes. Available at: https://www.skyworksinc.com/Products/Diodes/SMS7630-Series
  31. El Mattar, S., Baghdad, A., Ballouk, A. (2022). A 2.45/5.8 GHz high-efficiency dual-band rectifier for low radio frequency input power. International Journal of Electrical and Computer Engineering (IJECE), 12 (3), 2169. https://doi.org/10.11591/ijece.v12i3.pp2169-2176
  32. Bhatt, K., Kumar, S., Kumar, P., Tripathi, C. C. (2019). Highly Efficient 2.4 and 5.8 GHz Dual-Band Rectenna for Energy Harvesting Applications. IEEE Antennas and Wireless Propagation Letters, 18 (12), 2637–2641. https://doi.org/10.1109/lawp.2019.2946911
Substantiating the criteria for selecting rectifier diodes for low-power rectenna energy harvesting systems

Downloads

Published

2026-04-29

How to Cite

Alieksieiev, V., Hretskykh, D., Havva, D., Nesterenko, M., & Ivanova, O. (2026). Substantiating the criteria for selecting rectifier diodes for low-power rectenna energy harvesting systems. Eastern-European Journal of Enterprise Technologies, 2(8 (140), 17–28. https://doi.org/10.15587/1729-4061.2026.355841

Issue

Section

Energy-saving technologies and equipment