Investigation of steam generation performance on conical cavity receiver by different geometric concentration ratios for fresnel lens solar concentrator
DOI:
https://doi.org/10.15587/1729-4061.2020.209778Keywords:
steam performance, Fresnel lens, solar concentrator, conical cavity, receiver, temperature, direct normal irradiation, geometric concentration ratio, latent heat, efficiencyAbstract
The paper discusses the comparison of the performance of steam generators in large and small receivers, using a Fresnel lens concentrator.
The goal is to get the best value from the efficiency of a steam generator between large and small receivers, with the following task details:
a) design a conical cavity receiver that has the most efficient geometric concentration ratio;
b) compare the thermal efficiency of conical cavity receivers that have different geometric concentration ratios;
c) analyze the potential of the steam energy from the conical cavity receiver produced by the PMMA Fresnel lens concentrator based on the amount of average radiation directly at the study site.
The study uses an experimental field research method, which is conducted outdoors. This research was conducted in the energy conversion laboratory, Universitas Brawijaya (Latitude: 7.9553° S and Longitude: 112.6145° W), in September 2019. The PMMA Fresnel lens is used for the solar thermal concentrators. The two receivers with a conical cavity that were compared were made of copper with a volume of 2 litres and 0.25 litres, respectively. They are coated with a glass wool insulator with a thickness of 10 mm. Direct Normal Irradiance (Ib) is measured by a solar power meter. The cup anemometer is used to measure wind speed (vw) around the receiver. Digi-Sense 12 Channel Scanning Benchtop Thermometer connected to the laptop is used to measure temperature. The positions of the four K-type thermocouples are as follows:
1) ambient temperature (Ta);
2) focal point temperature (Tf);
3) receiver wall temperature (Tr);
4) steam/water temperature (Tw).
A pressure gauge to measure the pressure of the steam that goes to the measuring cup was used. After saturation pressure (Psat) has been reached, it will be known from the condensation process through the copper coil, which functions as a condenser.
From the results of the study, the large receivers have specifications CRg=8 and a volume of 2 litres of water. Whereas, the small receiver is CRg=30 and 0.25 L. The large receivers can produce steam latent heat energy Qs=1.37 MJ per cycle with useful efficiency (utilization efficiency) ηTh=31.81 %. Whereas the small receiver can produce steam energy, Qs=579.17 kJ per cycle with useful efficiency, ηTh=33.31 %. Hence, from the two types of conical cavity receivers, small receivers have that higher effectiveness than large ones can be recommendedReferences
- Mohtasham, J. (2015). Review Article-Renewable Energies. Energy Procedia, 74, 1289–1297. doi: https://doi.org/10.1016/j.egypro.2015.07.774
- Widén, J., Munkhammar, J. (2019). Solar Radiation Theory. Uppsala: Uppsala University, 50. doi: https://doi.org/10.33063/diva-381852
- Kalogirou, S. A. (2004). Environmental benefits of domestic solar energy systems. Energy Conversion and Management, 45 (18-19), 3075–3092. doi: https://doi.org/10.1016/j.enconman.2003.12.019
- Mousavi Maleki, S., Hizam, H., Gomes, C. (2017). Estimation of Hourly, Daily and Monthly Global Solar Radiation on Inclined Surfaces: Models Re-Visited. Energies, 10 (1), 134. doi: https://doi.org/10.3390/en10010134
- Al-Dabbas, M. A. (2010). The analysis of the characteristics of the solar radiation climate of the daily global radiation and diffuse radiation in Amman, Jordan. International Journal of Renewable Energy, 5 (2), 23–38.
- Scarpa, F., Marchitto, A., Tagliafico, L. (2017). Splitting the solar radiation in direct and diffuse components; insights and constrains on the clearness-diffuse fraction representation. International Journal of Heat and Technology, 35 (2), 325–329. doi: https://doi.org/10.18280/ijht.350213
- Law, E. W., Prasad, A. A., Kay, M., Taylor, R. A. (2014). Direct normal irradiance forecasting and its application to concentrated solar thermal output forecasting – A review. Solar Energy, 108, 287–307. doi: https://doi.org/10.1016/j.solener.2014.07.008
- Geddam, S., Dinesh, G. K., Sivasankar, T. (2015). Determination of thermal performance of a box type solar cooker. Solar Energy, 113, 324–331. doi: https://doi.org/10.1016/j.solener.2015.01.014
- Onokwai, A. O., Okonkwo, U. C., Osueke, C. O., Olayanju, T. M. A., A Ezugwu, C., Diarah, R. S. et. al. (2019). Thermal Analysis of Solar Box Cooker in Omu-Aran Metropolis. Journal of Physics: Conference Series, 1378, 032065. doi: https://doi.org/10.1088/1742-6596/1378/3/032065
- Sarbu, I., Sebarchievici, C. (2018). A comprehensive review of thermal energy storage. Sustainability, 10 (1), 191. doi: https://doi.org/10.3390/su10010191
- Dai, Y., Ma, J. (2017). Efficient Solar Cooling by Using Variable Effect LiBr-H2O Absorption Chiller and Linear Fresnel Solar Collector with Cavity Receiver. Proceedings of SWC2017/SHC2017. doi: https://doi.org/10.18086/swc.2017.28.03
- Xie, W. T., Dai, Y. J., Wang, R. Z., Sumathy, K. (2011). Concentrated solar energy applications using Fresnel lenses: A review. Renewable and Sustainable Energy Reviews, 15 (6), 2588–2606. doi: https://doi.org/10.1016/j.rser.2011.03.031
- Wang, L., Yuan, Z., Zhao, Y., Guo, Z. (2019). Review on Development of Small Point-Focusing Solar Concentrators. Journal of Thermal Science, 28 (5), 929–947. doi: https://doi.org/10.1007/s11630-019-1134-4
- Xie, W. T., Dai, Y. J., Wang, R. Z. (2011). Numerical and experimental analysis of a point focus solar collector using high concentration imaging PMMA Fresnel lens. Energy Conversion and Management, 52 (6), 2417–2426. doi: https://doi.org/10.1016/j.enconman.2010.12.048
- Wang, H., Huang, J., Song, M., Hu, Y., Wang, Y., Lu, Z. (2018). Simulation and Experimental Study on the Optical Performance of a Fixed-Focus Fresnel Lens Solar Concentrator Using Polar-Axis Tracking. Energies, 11 (4), 887. doi: https://doi.org/10.3390/en11040887
- Wang, H., Huang, J., Song, M., Yan, J. (2019). Effects of receiver parameters on the optical performance of a fixed-focus Fresnel lens solar concentrator/cavity receiver system in solar cooker. Applied Energy, 237, 70–82. doi: https://doi.org/10.1016/j.apenergy.2018.12.092
- Mawire, A., Taole, S. H. (2014). Experimental energy and exergy performance of a solar receiver for a domestic parabolic dish concentrator for teaching purposes. Energy for Sustainable Development, 19, 162–169. doi: https://doi.org/10.1016/j.esd.2014.01.004
- Hijazi, H., Mokhiamar, O., Elsamni, O. (2016). Mechanical design of a low cost parabolic solar dish concentrator. Alexandria Engineering Journal, 55 (1), 1–11. doi: https://doi.org/10.1016/j.aej.2016.01.028
- Mahdi, K., Bellel, N. (2014). Estimation of steam production in a receiver under solar concentrating radiation. Contemporary Engineering Sciences, 7, 835–843. doi: https://doi.org/10.12988/ces.2014.4652
- Sanchez Vega, L. R. (2016). Modeling and experimental evaluation of a small-scale fresnel solar concentrator system. Renewables: Wind, Water, and Solar, 3 (1). doi: https://doi.org/10.1186/s40807-016-0021-9
- Udawant, R. R., Mohite, K. C., Takwale, M. G. (2016). Study of Performance of Fresnel Lens Solar Concentrator. International Journal of Energy Engineering, 6 (1A), 14–22.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2020 Asrori Asrori, Sudjito Suparman, Slamet Wahyudi, Denny Widhiyanuriyawan
This work is licensed under a Creative Commons Attribution 4.0 International License.
The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.
A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.
