This is an outdated version published on 2022-08-29. Read the most recent version.

Determining the dynamic model of the charging resonant converter with inductive coupling by an experimental-analytical method

Authors

DOI:

https://doi.org/10.15587/1729-4061.2022.263526

Keywords:

resonant charger, non-contact energy transfer, structural model, dynamic model

Abstract

This paper reports the advanced experimental-analytical method for determining the dynamic model of resonant converters of electricity. The object of research is semiconductor resonance converters and methods for analyzing their dynamics. The well-known experimental-analytical method for determining a dynamic model implements the sequence «experiment – analytics – dynamic model» when the structure of the system may be unknown. Then it is necessary to determine the structures and parameters of many dynamic models, among which the optimal ones will be selected. This makes it difficult to establish usable patterns.

Therefore, it is advisable to develop this method, according to which it is proposed to determine the parameters of the dynamic model according to the following sequence. First, carry out the analysis of the converter circuit and construct the dynamic models of sub-circuits. Next, an experiment is conducted with a simulation structural model of the converter, which is an input model of identification. After that, procedures are carried out for identifying and selecting optimal dynamic models among a set of initial identification models, as a result of which equivalent dynamics equations, gear ratios, and transfer functions of the selected converter models are obtained.

In the proposed modification of the method, the converter model is determined in advance, and at the identification stage it is enough to determine only its parameters. More simply, patterns are identified, and the number of initial identification models is significantly reduced. The results of using the proposed method on the example of determining the dynamic model of the charging resonance converter with inductive coupling between the charger and the battery of an autonomous object are given. The results of the presented analysis can be used in the design of resonant contactless chargers.

Author Biographies

Gennadiy Pavlov, Admiral Makarov National University of Shipbuilding

Doctor of Technical Sciences, Professor

Department of Computerized Control Systems

Andrey Obrubov, Admiral Makarov National University of Shipbuilding

PhD, Associate Professor

Department of Ship Power Systems

Irina Vinnichenko, Admiral Makarov National University of Shipbuilding

PhD, Associate Professor

Department of Computerized Control Systems

References

  1. Bose, B. K. (2013). Modern Power Electronics and AC Drives. PHI Learning Pvt Ltd.
  2. Siroos, A., Sedighizadeh, M., Afjei, E., Fini, A. S., Yarkarami, S. (2021). Correction to: System Identification and Control Design of a Wireless Charging Transfer System with Double-Sided LCC Converter. Arabian Journal for Science and Engineering, 46 (10), 10287–10288. doi: https://doi.org/10.1007/s13369-021-05726-0
  3. Pavlov, G., Obrubov, A., Vinnychenko, I. (2021). Design Procedure of Static Characteristics of the Resonant Converters. 2021 IEEE 3rd Ukraine Conference on Electrical and Computer Engineering (UKRCON). doi: https://doi.org/10.1109/ukrcon53503.2021.9575698
  4. Pavlov, G., Pokrovskiy, M., Vinnichenko, I. (2018). Load Characteristics of the Serial-to-serial Resonant Converter with Pulse-number Regulation for Contactless Inductive Energy Transfer. 2018 IEEE 3rd International Conference on Intelligent Energy and Power Systems (IEPS). doi: https://doi.org/10.1109/ieps.2018.8559590
  5. Pavlov, G., Obrubov, A., Vinnichenko, I. (2016). The linearized dynamic model of the series resonant converter for small signals. 2016 2nd International Conference on Intelligent Energy and Power Systems (IEPS). doi: https://doi.org/10.1109/ieps.2016.7521879
  6. Tian, H., Tzelepis, D., Papadopoulos, P. N. (2021). Electric Vehicle Charger Static and Dynamic Modelling for Power System Studies. Energies, 14 (7), 1801. doi: https://doi.org/10.3390/en14071801
  7. Tian, S., Lee, F. C., Li, Q., Li, B. (2015). Small-signal equivalent circuit model of series resonant converter. 2015 IEEE Energy Conversion Congress and Exposition (ECCE). doi: https://doi.org/10.1109/ecce.2015.7309685
  8. Yin, Y., Zane, R., Erickson, R., Glaser, J. (2003). Direct modeling of envelope dynamics in resonant inverters. IEEE 34th Annual Conference on Power Electronics Specialist, 2003. PESC ’03. doi: https://doi.org/10.1109/pesc.2003.1216778
  9. Jain, A., Massimiani, I. C. (2021). LCC Resonant Converter Design and Transfer Function Computation Using FHA Analysis. 2021 4th Biennial International Conference on Nascent Technologies in Engineering (ICNTE). doi: https://doi.org/10.1109/icnte51185.2021.9487672
  10. González-González, J., Triviño-Cabrera, A., Aguado, J. (2018). Design and Validation of a Control Algorithm for a SAE J2954-Compliant Wireless Charger to Guarantee the Operational Electrical Constraints. Energies, 11 (3), 604. doi: https://doi.org/10.3390/en11030604
  11. Zheng, K., Zhang, G., Zhou, D., Li, J., Yin, S. (2018). Modeling, dynamic analysis and control design of full-bridge LLC resonant converters with sliding-mode and PI control scheme. Journal of Power Electronics, 18 (3), 766–777. doi: https://doi.org/10.6113/JPE.2018.18.3.766
  12. Wang, W., Shi, Y., Yang, D. (2008). A New Modeling Method for the Switching Power Converter. 2008 Workshop on Power Electronics and Intelligent Transportation System. doi: https://doi.org/10.1109/peits.2008.117
  13. Valdivia, V., Barrado, A., Lazaro, A., Fernandez, C., Zumel, P. (2010). Black-box modeling of DC-DC converters based on transient response analysis and parametric identification methods. 2010 Twenty-Fifth Annual IEEE Applied Power Electronics Conference and Exposition (APEC). doi: https://doi.org/10.1109/apec.2010.5433361
  14. Valdivia, V., Barrado, A., Laazaro, A., Zumel, P., Raga, C., Fernandez, C. (2009). Simple Modeling and Identification Procedures for “Black-Box” Behavioral Modeling of Power Converters Based on Transient Response Analysis. IEEE Transactions on Power Electronics, 24 (12), 2776–2790. doi: https://doi.org/10.1109/tpel.2009.2030957
  15. Gilat, A. (2014). MATLAB: An Introduction with Applications. Wiley. Available at: https://www.academia.edu/20361006/MATLAB_5th_Edition
  16. Dongming, G., Dangshu, W. (2021). Research on Transmission Characteristics of Dual LCL Resonance Compensation Topology in Wireless Charging System. 2021 IEEE 5th Information Technology,Networking,Electronic and Automation Control Conference (ITNEC). doi: https://doi.org/10.1109/itnec52019.2021.9586815
  17. Pentegov, I. V., Rymar, S. V., Volkov, I. V. (2006). Svyaz' mezhdu parametrami elektromagnitnykh, printsipial'nykh skhem i skhem zamescheniya dvukhobmotochnykh transformatorov. Elektrotekhnika i Elektromekhanika, 3, 67–79. Available at: https://www.researchgate.net/publication/313140828_Svaz_mezdu_parametrami_elektromagnitnyh_principialnyh_shem_i_shem_zamesenia_dvuhobmotocnyh_transformatorov_Link_between_parameters_of_electromagnetic_principle_circuits_and_equivalent_circuits_of_doub
  18. Wan, H. (2012). High Efficiency DC-DC Converter for EV Battery Charger Using Hybrid Resonant and PWM Technique. Blacksburg, 115. Available at: https://vtechworks.lib.vt.edu/bitstream/handle/10919/32343/Wan_HM_T_2012.pdf

Downloads

Published

2022-08-29

Versions

How to Cite

Pavlov, G., Obrubov, A., & Vinnichenko, I. (2022). Determining the dynamic model of the charging resonant converter with inductive coupling by an experimental-analytical method . Eastern-European Journal of Enterprise Technologies, 4(8 (118), 17–28. https://doi.org/10.15587/1729-4061.2022.263526

Issue

Vol. 4 No. 8 (118) (2022): Energy-saving technologies and equipment

Section

Energy-saving technologies and equipment

License

Copyright (c) 2022 Gennadiy Pavlov, Andrey Obrubov, Irina Vinnichenko

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

The consolidation and conditions for the transfer of copyright (identification of authorship) is carried out in the License Agreement. In particular, the authors reserve the right to the authorship of their manuscript and transfer the first publication of this work to the journal under the terms of the Creative Commons CC BY license. At the same time, they have the right to conclude on their own additional agreements concerning the non-exclusive distribution of the work in the form in which it was published by this journal, but provided that the link to the first publication of the article in this journal is preserved.

A license agreement is a document in which the author warrants that he/she owns all copyright for the work (manuscript, article, etc.).
The authors, signing the License Agreement with TECHNOLOGY CENTER PC, have all rights to the further use of their work, provided that they link to our edition in which the work was published.
According to the terms of the License Agreement, the Publisher TECHNOLOGY CENTER PC does not take away your copyrights and receives permission from the authors to use and dissemination of the publication through the world's scientific resources (own electronic resources, scientometric databases, repositories, libraries, etc.).
In the absence of a signed License Agreement or in the absence of this agreement of identifiers allowing to identify the identity of the author, the editors have no right to work with the manuscript.
It is important to remember that there is another type of agreement between authors and publishers – when copyright is transferred from the authors to the publisher. In this case, the authors lose ownership of their work and may not use it in any way.